408-4354 Datasheet, PDF (1/5 Pages) Tyco Electronics – Read these instructions thoroughly before crimping any contacts

PRO-CRIMPER* III Hand
Crimping Tool Assembly 58591-1
with Die Assembly 58591-2
Instruction Sheet
408-4354
11 JUN 09 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator Assembly
(Supplied with
Die Assembly)
Front of Tool
(Locator Side)
Stationary Jaw
Back of Tool
(Wire Side)
Pivot Pin
Die Assembly
Moving Jaw
PRO-CRIMPER III Hand
Crimping Tool Frame
354940-1 (408-9930)
Ratchet Adjustment Wheel
The PRO-CRIMPER III Hand Crimping Tool Assembly is a Commercial"
grade tool and is designed primarily for field installation, repair, maintenance
work, or prototyping in industrial, commercial, or institutional applications.
Product crimped with this tool will meet the crimp height requirement for hand
tools in the appropriate 114 series specification, but may not comply with other
feature parameters of the specification. Tyco Electronics offers a variety of
tools to satisfy your performance requirements. For additional information,
contact the Tooling Assistance Center at 1-800-722-1111.
Stationary Handle
Moving Handle
TE Die
Assembly
{ ^{TE Locator}
Assembly
} ^Contact
Family
Size
(mm²)
Wire
Insul Dia
(mm [in.])
Strip Length
(mm [in.])
Micro
0.75
58591-2
58515-3
Power
Quadlok
1.0
3.40
[.134]
3.81 - 4.60
[.150 - .181]
Seal
0.5
{ Supplied with die assembly, also available separately.
} Contact the Tooling Assistance Center or Product
Information Center (see below) for specific contact part
numbers.
Figure 1
1. INTRODUCTION
PRO–CRIMPER III Hand Crimping Tool Assembly
58591–1 consists of Die Assembly 58591–2 and
PRO–CRIMPER III Hand Crimping Tool Frame
354940–1. The die assembly consists of crimping
dies and a locator assembly.
Read these instructions thoroughly before crimping
any contacts.
Reasons for revision are listed in Section 11,
REVISION SUMMARY.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
2. DESCRIPTION (Figures 1 and 2)
The tool features a tool frame with a stationary jaw
and handle, a moving jaw, a moving handle, and an
adjustable ratchet that ensures full contact crimping.
The tool frame holds a die assembly with three
crimping sections.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B