408-4291 Datasheet, PDF (1/3 Pages) Tyco Electronics – Reasons for revision can be found in Section 9, REVISION SUMMARY.

PRO-CRIMPER* III Hand
Crimping Tool Assembly 58622-1
with Die Assembly 58622-2
Instruction Sheet
408-4291
20 MAY 09 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Front of Tool
Die
Assembly
58622-2
Stationary Jaw
Back of Tool
(Wire Side)
Pivot Pin
PRO-CRIMPER III Hand
Crimping Tool Frame
354940-1 (408-9930)
Moving Jaw
Ratchet Adjustment
Wheel
The PRO-CRIMPER III Hand Crimping Tool is a Commercial" grade tool
and is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate 114 series specification, but may not comply with other
feature parameters of the specification. Tyco Electronics offers a variety of
tools to satisfy your performance requirements. For additional information,
contact the Tooling Assistance Center at 1-800-722-1111.
Stationary
Handle
Moving
Handle
Figure 1
1. INTRODUCTION
This tool is designed to crimp Coaxial Series F
connectors onto cable Series 59, Series 6, and
Series 7 Quad.
Catalog 124359 provides a selection of Coaxial
Series F connectors. For connectors not referenced
in the catalog, contact Tyco Electronics Product
Engineering for connector recommendations.
PRO–CRIMPER III Hand Crimping Tool Assembly
58622–1 consists of Die Assembly 58622–2 and
PRO–CRIMPER III Hand Crimping Tool Frame
354940–1. See Figure 1.
For instructions concerning the operation of the hand
tool, refer to instruction sheet 408–9930.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
Reasons for revision can be found in Section 9,
REVISION SUMMARY.
2. DESCRIPTION (Figure 1)
The tool features a tool frame with a stationary jaw
and handle, a moving jaw, a moving handle, and an
adjustable ratchet that ensures full connector
crimping. The tool frame holds the die assembly.
The die assembly features identical upper and lower
crimping dies and two ferrule crimp sections. The
ferrule crimp sections are identified by their hex size.
Each die is held in the hand tool by a single screw.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 3
LOC B