408-4275 Datasheet, PDF (1/6 Pages) Tyco Electronics – PRO-CRIMPER III Hand Crimping Tool Assembly

PRO- CRIMPER* III Hand Crimping
Tool Assembly 58611- 1 and
Die Assembly 58611- 2
Instruction Sheet
408- 4275
31 DEC 09 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Locator Assembly
(Supplied with the
Die Assembly)
Stationary Jaw
Back of Tool
(Wire Side)
Front of Tool
(Locator Side)
Die Assembly
Moving Jaw
Ratchet
Adjustment
Wheel
The PRO- CRIMPER III Hand Crimping Tool is a “Commercial” grade
hand tool and is designed primarily for field installation, repair,
maintenance work, or prototyping in industrial, commercial, or
institutional applications. Product crimped with this tool will meet the
crimp height requirements for hand tools in the appropriate 114 series
specification, but may not comply with other feature parameters of the
specification. Tyco Electronics offers a variety of tools to satisfy your
performance requirements. For additional information, contact the
Tooling Assistance Center at 1- 800- 722- 1111.
Pivot Pin
PRO- CRIMPER III Hand
Crimping Tool Frame
354940- 1 (408- 9930)
Stationary
Handle
Moving Handle
Die Assembly Locator Assembly{ Contact Family}
Size
mm²
Wire
Insul Dia
(mm [in.])
0.2 -- 0.35
58611--2
58515--1
MQS
Receptacle
1.90
[.075]
0.5 -- 0.6
{ Supplied with die assembly, also available separately.
} Contact the Tooling Assistance Center or Product Information (see below) for specific contact part numbers.
Figure 1
Strip Length
(mm [in.])
2.97 -- 3.23
[.116 -- .127]
1. INTRODUCTION
PRO--CRIMPER III Hand Crimping Tool 58611--1
Assembly consists of Die Assembly 58611--2 and
PRO--CRIMPER III Hand Crimping Tool Frame
354940--1. The die assembly consists of crimping
dies and a locator assembly. Read these instructions
thoroughly before crimping any contacts.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalent s provided in brackets.] Figures
and illustrations are not drawn to scale.
Revisions of this instruction sheet can be found in
Paragraph 11, REVISION SUMMARY.
E2009 Tyco Electronics Corporation, Harrisburg, PA TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All International Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 6
LOC B