408-4214 Datasheet, PDF (1/5 Pages) Tyco Electronics – Installation and removal of the crimper from the tool holder assembly

Tool Holder
Assembly
189928- 1
(Ref)
“T”- HEAD* Crimper 217202- 1
(Used with 626 Pneumatic Tooling Systems)
Instruction Sheet
408- 4214
12 MAR 10 Rev A
“T”- HEAD Crimper
217202- 1
Quick Pins
(Ref)
Figure 1
1. INTRODUCTION
“T”--HEAD Crimper 217202--1 is designed to crimp
PIDG* and PLASTI--GRIP* terminals on wire sizes
22--14 AWG. The crimper is used with 626 Pneumatic
Tooling Assemblies 189721--1, 189722--1, 189723--1,
and 189724--1. For information concerning the setup
and operation of the pneumatic tools, refer to
Customer Manual 409--5862.
This instruction sheet provides:
S Installation and removal of the crimper from the
tool holder assembly.
S Maintenance, inspection, and repair information
for the crimper.
For information concerning wire preparation, crimping
procedures, and crimp inspection, refer to the
associated instructions supplied with the terminals.
Read these instructions thoroughly before
proceeding.
NOTE
i
Measurements are in metric units [followed by
U.S. customary units in brackets]. Figures and
illustrations are not drawn to scale and are for
reference only.
2. DESCRIPTION (Figure 1)
The “T”--HEAD Crimper attaches (via four quick pins)
to the tool holder assembly of the pneumatic power
unit. When actuated, a cam extends through the tool
holder into the crimper, driving an internal, roller--
guided envelope. The other end of this mechanism is
connected to an anvil and, as the cam pushes against
the roller--guided envelope, the anvil moves in a
straight line and bottoms against a stationary
indenter. When the cam of the pneumatic tool
retracts, the force is removed from the envelope.
The envelope must then be manually retracted by use
of a plastic slide switch. The plastic slide switch
permits opening and closing of the anvil for insertion
and removal of terminals or splices.
3. INSTALLATION AND REMOVAL OF CRIMPER (Figure 1)
Before installing the crimper, refer to Customer
Manual 409--5862 for instructions on installing the
appropriate tool holder assembly (including cam) on
the pneumatic tool. After the appropriate tool holder
assembly has been installed, proceed as follows:
NOTE
i
Removal is the reverse of installation.
E2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other product names, logos, or company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B