English
Language : 

408-4198 Datasheet, PDF (1/6 Pages) Tyco Electronics – This instruction sheet covers the application and maintenance procedures for Pneumatic Crimping Head Assembly
Pneumatic Crimping Head Assembly 314991-1
for AMPLI-BOND* and PLASTI-GRIP* Terminals
Instruction Sheet
408-4198
27 APR 09 Rev B
Locking
Bead
Mounting
Lugs
Pneumatic
Tool 69015
(Ref)
Anvil
Links
Toggle
Link
Indenter
Pneumatic
Crimping Head
Assembly
314991-1
Assembly
Pin
Toggle
Lever
Toggle
Arm
Figure 1
1. INTRODUCTION
This instruction sheet covers the application and
maintenance procedures for Pneumatic Crimping
Head Assembly 314991–1. The crimping head
assembly is designed for use in Pneumatic Tool
69015 to crimp AMPLI–BOND and PLASTI–GRIP
terminals on stranded copper wire size 4 AWG.
For further information concerning setup procedures,
refer to instruction sheet 408–1310, which is
packaged with the pneumatic tool. For additional
information on AMPLI–BOND and PLASTI–GRIP
terminals, refer to Tyco Electronics Catalogs 82038
and 82042.
Reasons for reissue are listed Section 8, REVISION
SUMMARY.
Read these instructions thoroughly before crimping
any terminals.
NOTE
Dimensions on this sheet are in metric units [with
U.S. customary units in brackets]. Figures and
i
illustrations are for identification only and are not
drawn to scale.
2. DESCRIPTION
The crimping head assembly features two crimping
areas, each marked on the front side of the head to
show the wire size. The integral jaws (indenter and
anvil) close in an arc–like motion. The assembly
includes two toggle links, two links, and one toggle
lever. See Figure 1.
Terminals and heads are color coded as listed in
Figure 2. Dies have the terminal size stamped on the
wire barrel crimp sections of dies.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 6
LOC B