408-4174 Datasheet, PDF (1/1 Pages) Tyco Electronics – High Current Extraction Tools

High Current Extraction Tools
679916- 1, 679917- 1, and 679918- 1
Instruction Sheet
408- 4174
11 MAR 10 Rev A
Push Rod
Push Rod
Button
Sleeve
Handle
Figure 1
1. INTRODUCTION (See Figure 1)
High Current Extraction Tools 679916--1, 679917--1,
and 679918--1 are designed to remove High Current
Pin and Socket Contacts 193837--[ ] and 193673--[ ]
from their housings. Read these instructions
thoroughly before using the tool.
NOTE
i
Housings are customer supplied and must be
designed to meet specifications by Tyco
Electronics.
2. DESCRIPTION
The extraction tool consists of a push rod button,
push rod, handle, and sleeve. The sleeve is inserted
into the mating face of the housing, depressing the
locking lances of the crimped contact and allowing the
contact to be extracted from the wire end of the
housing.
3. EXTRACTION PROCEDURE (See Figure 2)
1. Align the sleeve of the tool with the contact to
be removed.
2. Holding the handle, insert the sleeve into the
housing cavity until the sleeve bottoms. Allow the
push rod to slide out of the handle.
3. While holding the sleeve in position, depress the
push rod button. The contact will emerge from the
wire end of the housing as the button is depressed;
then pull contact free from housing.
NOTE
i
If contact is not easily removed, carefully repeat
the extraction procedure.
4. MAINTENANCE AND INSPECTION
It is recommended that the tool be inspected when
you receive it and at regularly scheduled intervals.
The tool is not repairable, and it should be replaced
when it is worn or damaged. Store the extraction tool
in a clean, dry place and clean the extraction tool with
a soft, lint--free cloth.
Order extraction tools through your Representative, or
call 1--800--526--5142, or send a facsimile of your
purchase order to 1--717--986--7605, or write to:
CUSTOMER SERVICE (38--35)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
5. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated instruction sheet to corporate
requirements
Housing (Customer
Supplied)
Housing
Cavity
Locking Lance(s)
of Pin Contact
Push Rod
(Extended)
Wire End
of Housing
Figure 2
E2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products names, logos, or company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 1
LOC B