408-4160 Datasheet, PDF (1/4 Pages) Tyco Electronics – PRO-CRIMPER III Hand Crimping Tool

PRO-CRIMPER* III Hand Crimping
Tool Assembly 224933-1
with Die Assembly 224933-2
Instruction Sheet
408-4160
11 MAY 09 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator
Assembly
(Supplied with
Die Assembly)
Front of Tool
(Locator Side)
Stationary Jaw
Back of Tool
(Wire Side)
Pivot Pin
Die
Assembly
Moving Jaw
PRO-CRIMPER III Hand
Crimping Tool Frame
354940-1 (408-9930)
Ratchet
Adjustment
Wheel
PRO-CRIMPER III Hand Crimping Tool is a Commercial" grade tool and is
designed primarily for field installation, repair, maintenance work, or prototyping
in industrial, commercial, or institutional applications. Product crimped with this
tool will meet the crimp height requirement for hand tools in the appropriate 114
series application specification, but may not comply with other feature parameters
of the specification. Tyco Electronics offers a variety of tools to satisfy your
performance requirements. For additional information, contact the Tooling
Assistance Center at 1-800-722-1111.
Stationary
Handle
Moving Handle
TE
Die Assembly
TE
{
Locator Assembly
} Connector
Family
Size
(AWG)
Cable
Insulation
Diameter
Shield
Type
224933-2
58515-1
{ Supplied with die assembly. Also available separately.
1. INTRODUCTION
INFOPORT*
3.43 to 3.81 mm
[.135 to .150 in.]
Small
Series III
Shield Kit
28-32
5.72 x 3.68 mm
[.225 x .145 in.]
Large
OVAL
}
Contact the Tooling Assistance Center or Product Information Center (below) for specific
shield part numbers.
Figure 1
PRO–CRIMPER III Hand Crimping Tool
Assembly 224933–1 consists of Die Assembly
224933–2 and PRO–CRIMPER III Hand Crimping
Tool Frame 354940–1. The die assembly consists of
crimping dies and a locator assembly.
Read these instructions thoroughly before crimping.
NOTE
i
Dimensions on this instruction sheet are in
millimeters [with inch equivalents provided in
brackets]. Figures and illustrations are for
identification only and are not drawn to scale.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 4
LOC B