408-4145 Datasheet, PDF (1/4 Pages) Tyco Electronics – PRO–CRIMPER III Hand Tool Assembly

PRO-CRIMPER* III
Hand Tool Assembly 217212-1
with Die Assembly 217212-2
Instruction Sheet
408-4145
20 MAR 09 Rev D
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Front of Tool
Stationary
Jaw
Back of Tool
(Wire Side)
Die Assembly
217212-2
PRO-CRIMPER III Hand Tool
Frame 354940-1
(See Instruction Sheet 408-9930)
Moving
Jaw
CERTI-CRIMP*
Ratchet
The PRO-CRIMPER III Hand Tool is a Commercial" grade tool and is
designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate 114 Application Specification, but may not comply with other
feature parameters of the specification. Tyco Electronics offers a variety of
tools to satisfy your performance requirements. For additional information,
contact the Tooling Assistance Center at 1-800-722-1111.
Moving
Handle
Stationary
Handle
DIE
ASSEMBLY
CRIMPING
CHAMBER
Outer
Center
Inner
CLOSED-END
SPLICE
PART
NUMBER
TYPE
35115
ECV
ECN
328730
ECV
ECN
35653
ECN
WIRE
SIZE RANGE
(AWG)
CIRCULAR MIL
AREA RANGE
STRIP LENGTH
SOLID OR STRANDED
WIRE COMBINATION
TABLE SHOWN ON
(INSTRUCTION SHEET)
22-14
509-5,180
8.76 +0.38 [.345 +.016]
(408-1271)
22-10
22-10
3,248-13,100
11.12 +0.38 [.438 +.016]
3,248-13,100
Figure 1
11.12 +0.38 [.438 +.016]
(408-1003)
(408-1021)
1. INTRODUCTION
PRO–CRIMPER III Hand Tool Assembly 217212–1
consists of Die Assembly 217212–2 and
PRO–CRIMPER III Hand Tool Frame 354940–1. The
die assembly consists of two crimping dies. Read
these instructions thoroughly before crimping any
splices.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
Reasons for reissue of this instruction sheet are
provided in Section 9, REVISION SUMMARY.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 4
LOC B