408-4116 Datasheet, PDF (1/4 Pages) Tyco Electronics – Crimping Die Assembly

Adjustment
Screw
Nut
Straightener
Crimping Die Assembly
58559- 1
Instruction Sheet
408- 4116
11 MAR 10 Rev A
Spring
Retainer
Locator
Stationary Jaw
(Ref)
PRO- CRIMPER III Frame
Assembly 354940- 1 (Ref)
Spring
Indenter Die
Anvil Die
Movable Jaw
(Ref)
Die Retaining
Screws (Ref)
Figure 1
1. INTRODUCTION
Crimping Die Assembly 58559--1 is designed to crimp
Consumer RF Series BNC plug connectors when
used in PRO--CRIMPER III Frame Assembly
354940--1. Read these instructions thoroughly before
using the die assembly.
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures are
not drawn to scale.
Reasons for reissue of this instruction sheet are
provided in Section 8, REVISION SUMMARY.
When mated, the dies form two crimping chambers.
The small crimping chamber crimps the center
contact onto the center conductor of the coaxial cable
and the large crimping chamber crimps the ferrule of
the connector onto the coaxial cable. The ferrule
crimping chamber actually places two different size
crimps on the ferrule; one crimp in the connector
support sleeve area, and another crimp in the cable
insulation area directly behind the cable braid.
The locator and straightener assembly properly
positions and holds the center contact of the
connector during the crimping procedure.
3. INSTALLATION AND REMOVAL OF DIE ASSEMBLY
(See Figure 1)
2. DESCRIPTION (See Figure 1)
The die assembly consists of an indenter die and an
anvil die. The die assembly features a locator and
straightener assembly (straightener, adjustment
screw, nut, spring retainer, and spring). Each die is
held in the tool jaws by a single screw.
1. Close the tool handles until the ratchet releases,
then allow the handles to open fully.
2. Remove the two die retaining screws from the
tool jaws.
3. Install the anvil die in the movable jaw of the
tool. Insert the short die retaining screw through
E2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products names, logos, or company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 4
LOC B