408-4091 Datasheet, PDF (1/5 Pages) Tyco Electronics – PRO–CRIMPER III Hand Crimping Tool

PRO-CRIMPER* III Hand
Crimping Tool Assembly 58558-1
with Die Assembly 58558-2
Instruction Sheet
408-4091
08 MAY 09 Rev B
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator and
Straightener
Assembly
Die Assembly
58558-2
Stationary
Jaw
Back of Tool
(Wire Side)
PRO-CRIMPER III Hand
Crimping Tool Assembly
Frame 354940-1 (408-9930)
Moving
Jaw
Ratchet
Adjustment
Wheel
The PRO-CRIMPER III Hand Crimping Tool is a Commercial" grade tool and
is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate 114 application specification, but may not comply with other
feature parameters of the specification. Tyco Electronics offers a variety of
tools to satisfy your performance requirements. For additional information,
contact the Technical Assistance Center at 1-800-722-1111.
Stationary
Handle
Moving
Handle
Figure 1
1. INTRODUCTION
PRO–CRIMPER III Hand Crimping Tool Assembly
58558–1 consists of Die Assembly 58558–2 and
PRO–CRIMPER III Hand Crimping Tool Frame
354940–1. The hand tool assembly is used to crimp
Consumer RF Series BNC Plug Connectors onto
various sizes of RG/U cable.
For additional information on the hand tool frame,
refer to 408–9930.
Reasons for reissue are provided in Section 9,
REVISION SUMMARY.
2. DESCRIPTION (Figures 1 and 2)
The hand tool assembly features a tool frame with a
stationary jaw and handle, a moving jaw, a moving
handle, and an adjustable ratchet that ensures full
contact crimping. The tool frame holds a die assembly
with four crimping chambers. The die assembly
features an indenter die and an anvil die.
Read these instructions thoroughly before using the
hand tool assembly.
Attached to the outside of the frame is a locator and
straightener assembly, which properly positions and
holds the connector center contact during crimping.
NOTE
i
Dimensions on this sheet are in millimeters
[with inches in brackets]. Figures are not drawn
to scale.
Die retaining pins and die retaining screws are used
to position and secure the dies in the tool frame. A
nut is used on the upper die retaining screw to hold
the locator and straightener assembly in place.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B