408-4021 Datasheet, PDF (1/6 Pages) Tyco Electronics – PRO-CRIMPER* III Hand Crimping Tool

PRO- CRIMPER* III Hand Crimping
Tool Assembly 58535- 1 with
Die Assembly 58535- 2
Instruction Sheet
408- 4021
29 JUL 09 Rev C
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Locator
Assembly
(Supplied with
Die Assembly)
Front of Tool
(Lower Side)
Stationary Jaw
Back of Tool
(Wire Side)
Pivot Pin
Die
Assembly
Moving Jaw
PRO- CRIMPER III
Hand Crimping Tool
Frame 345940- 1
(408- 9930)
Ratchet
Adjustment
Wheel
The PRO- CRIMPER III Hand Crimping Tool Assembly is a “Commercial”
grade tool and is designed primarily for field installation, repair, maintenance
work, or prototyping in industrial, commercial, or institutional applications.
Product crimped with this tool will meet the crimp height requirement for hand
tools in the appropriate 114 series specification, but may not comply with other
feature parameters of the specification. Tyco Electronics offers a variety of
tools to satisfy your performance requirements. For additional information,
contact the Technical Assistance Center at 1- 800- 722- 1111.
Stationary
Handle
Moving Handle
TE Die Assembly Locator Assembly^{
Contact
Family^}
Size
(AWG)
58535--2
58516--1
FFC Round Wire
Pin and Receptacle
Contacts
26--22
} Supplied with Die Assembly.. Also Available separately.
} Contact the Technical Assistance Center or Product Information (see below) for specific contact part numbers.
Figure 1
Wire
Ins. Dia.
(mm [In.])
1.0 to 1.4
[.040 to .056]
Strip Length
(mm [In.])
2.8 to 3.6
.110 to .140
1. INTRODUCTION
PRO--CRIMPER III Hand Crimping Tool
Assembly 58535--1 consists of Die Assembly
58535--2 and PRO--CRIMPER III Hand Crimping Tool
Frame 354940--1. The die assembly consists of
crimping dies and a locator assembly.
Read these instructions thoroughly before crimping
any contacts.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
Reasons for reissue are provided in Section 11,
REVISION SUMMARY.
2. DESCRIPTION (Figures 1 and 2)
The tool features a tool frame with a stationary jaw
and handle, a moving jaw, a moving handle, and an
E2009 Tyco Electronics Corporation, Harrisburg, PA TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All International Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 6
LOC B