408-4020 Datasheet, PDF (1/4 Pages) Tyco Electronics – This instruction sheet provides application and maintenance procedures for Hand Tool

PRO-CRIMPER* III
Hand Tool Frame Assemblies
58532-[ ], 58555-[ ], and 58588-[ ]
Instruction Sheet
408-4020
09 AUG 07 Rev B
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Stationary Jaw
Movable Jaw
Pivot Pin
Ratchet
Adjustment
Screw
Emergency
Ratchet
Release
Ratchet
Adjustment
Wheel
Die Retaining
Screws
The PRO-CRIMPER III Hand Tool is a Commercial" grade tool and is
designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate 114 application specification, but may not comply with other
feature parameters of the specification. Tyco Electtronics offers a variety of
tools to satisfy your performance requirements. For additional information,
contact the Tooling Assistance Center at 1-800-722-1111.
Figure 1
1. INTRODUCTION
This instruction sheet provides application and
maintenance procedures for Hand Tool Frame
Assembly 58532–[ ], 58555–[ ], and 58588–[ ]. The
tool is designed to accept interchangeable crimping
die assemblies for crimping various types of
connectors.
In most cases, the hand tool frame assembly is
provided with a specific set of dies and is considered
a component part of a crimping assembly. Refer to
the appropriate instruction sheet packaged with the
hand tool/crimping die assembly, or with the separate
die assembly, for information regarding crimping
procedures, crimp height inspection, and crimping die
gaging.
Read these instructions thoroughly before installing
dies and using the tool.
NOTE
i
The hand tool frame assembly is designed to
accept dies to crimp a variety of products.
Contact your local Tyco Electronics
Representative or the Tooling Assistance Center
for information regarding the availability of dies
for specific applications.
Reasons for reissue are provided in Section 7,
REVISION SUMMARY.
2. DESCRIPTION (Figure 1)
The hand tool consists of two crimping jaws, an
adjustable ratchet, spring–actuated handles, two die
retaining screws, and an emergency ratchet release.
The slotted design of the crimping jaws permits easy
installation and removal of crimping dies. The
adjustable ratchet allows handle pressure to be set
for optimum crimping die performance.
E2007 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 4
LOC B