408-2585 Datasheet, PDF (1/4 Pages) Tyco Electronics – Reasons for reissue of this instruction sheet are provided in Section 6, REVISION SUMMARY.

Die Assemblies
68240-1
68241-1
68242-1
68242-2
1338273-1
Indenter
Crimping Die Assemblies for
SOLISTRAND* Terminals
Die Assembly
68243-1
Nest
Mounting
Screw
Instruction Sheet
408-2585
20 AUG 08 Rev F
Retaining
Ring
G POWER UNIT
DIE
ASSEMBLY
Model T"
Terminating Machine
458000-4
AMP-O-LECTRIC*
Model G"
Terminating Unit
354501-[ ]
(409-5853)
AMP-O-LECTRIC
Model G"
Terminating Machine
354500-[ ]
(409-5842)
AMP-O-LECTRIC
Model K"
Terminating Machine
D 565435-5
(409-5128)
APPLICATOR
AMP-TAPETRONIC*
Machine
69875
(409-1993)
68250-1
(409-2586)
68240-1
68241-1
68242-1
687658-1
5
5
5
567200-3
5
5
5
567200-3
5
5
5
567200-2
---
5
5
5
5
5
5
68242-2
---
---
---
---
---
68243-1
5
5
5
5
5
1338273-1
5
5
5
5
5
G Customer manual shown in parenthesis. Contact Tooling Assistance Center at the number at the bottom of this page for more information.
D Model K" Terminating Machine 565435-5 has been superseded by Model G" Terminating Machine 354500-1 for new applications.
For existing applications, the Model K" can still be used.
Figure 1
---
---
---
---
5
---
---
1. INTRODUCTION
Crimping Die Assemblies listed in Figure 1 are
designed for use in the terminal applicators contained
in the power units listed. Each die assembly, when
installed in the terminal applicator, crimps
SOLISTRAND terminals onto the appropriate wire
size listed in Figure 2.
These instructions provide specific information
regarding the die assemblies and applicable
terminals. For information regarding operation of the
power unit, refer to the applicable customer manual.
Read these instructions and any referenced
instructions thoroughly before using the dies.
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures and
illustrations are for reference only and are not
drawn to scale.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
2. DESCRIPTION
Each die assembly features a nest die and indenter
die with mounting screws and retaining rings for
securing the dies to the applicator.
NOTE
i
The dies are coated with a preservative to
prevent rust and corrosion. Before use, wipe the
preservative from the dies, particularly from the
crimping surfaces.
E2008 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 4
LOC B