English
Language : 

408-10329 Datasheet, PDF (1/1 Pages) Tyco Electronics – Extraction Tool
Extraction Tool 2063080- 1
For MULTI- BEAM XL* Connectors
Instruction Sheet
408- 10329
30 OCT 09 Rev A
Handle
Two- Pronged
Tip
Using the Tool
1
Mating Face
of Connector
Figure 1
1. INTRODUCTION
Extraction Tool 2063080--1 is used to remove
individual contacts from MULTI--BEAM XL connectors
(reference part number 292499--1).
2. DESCRIPTION
The extraction tool is a handle with a two--pronged tip.
See Figure 1. When inserted in the contact cavity of
the connector, the tip will spread the locking latches of
the contact apart. This will enable the contact to be
pulled out from the wire end of the connector.
3. USING THE TOOL
1. At the mating face of the connector, align the tip
of the tool with the contact cavity of the contact to
be removed. See Figure 2.
2. Push the tip into the contact cavity until it
bottoms on the connector.
3. Holding the tool in place, gently pull the wire of
the contact until it is out of the connector.
NOTE
i
Contacts can be re- used if they are not deformed
or damaged.
4. REPLACEMENT AND REPAIR
The extraction tool is not repairable. Order
replacements through your representative, or call
1--800--526--5142, or send a facsimile of your
purchase order to 717--986--7605, or write to:
CUSTOMER SERVICE (038--035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
2
Tool Bottomed
on Connector
3
Gently Pull Wire
to Extract Contact
Figure 2
E2009 Tyco Electronics Corporation, Harrisburg, PA TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All International Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 1
LOC B