408-10324 Datasheet, PDF (1/5 Pages) Tyco Electronics – Cumulative Trauma Disorders can result from the prolonged use ofmanually powered hand tools

SDE PEW- 12 Hand Tool
Assembly 2063957- 1 with
Die Assembly 2063957- 2
Instruction Sheet
408- 10324
07 OCT 10 Rev C
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Locator
Nut
Die Set 2063957- 2
Wire Crimper
(Upper Die)
Lower
Contact
Support
Stationary
Jaw
Moving
Jaw
Handle
Emergency Ratchet
Release
Die Retention
Screws
Nut
Anvil (Lower)
Wire Die
Insulation
Crimper
(Upper Die)
Anvil (Lower)
Insulation Die
Ratchet
Adjustment
Wheel
Short Retaining
Pins (2)
Required
Long Retaining
Pins (2)
Required
DIE ASSEMBLY
PART NUMBER
2063957--2
CONTACT
(Pin)
2106124--9, 1--2106124--0,
1--2102164--1, 1--2102164--2
(Socket)
2106123--2, 2106123--4
SIZE
0.75--0.50 mm²
[18--20 AWG]
WIRE
INSULATION DIA
1.70--2.10
[.067--.083]
STRIP LENGTH
3.2--3.7
[.126--.146]
1. INTRODUCTION
Figure 1
2. DESCRIPTION
SDE PEW--12 Hand Tool Assembly 2063957--1
consists of SDE PEW--12 Frame Assembly
9--1478240--0 and die set assembly 2063957--2. See
Figure 1. The tool is used to crimp Slim Seal SSL
Contacts.
The tool frame features two jaws, a handle, ratchet
adjustment wheel, and an emergency ratchet release.
The die set consists of an indenter (upper die) and an
anvil (lower die). The tool frame holds a die assembly
with two crimping chambers. See Figure 1. Die
retaining pins and die retaining screws are used to
position and secure the dies in the tool frame.
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures and
illustrations are for reference only and are not
drawn to scale.
Reason for revision is given in Section 10, REVISION
SUMMARY.
The tool features a ratchet and an adjustment wheel
with a range of settings. The ratchet ensures that the
tool has completed the cycle and will not release until
the handles have been FULLY closed, unless the
emergency ratchet release is rotated to manually
release the ratchet. The adjustment wheel controls
the amount of handle pressure exerted on the dies
during the crimping procedure.
E2009 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other product names, logos, or company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B