408-10260 Datasheet, PDF (1/3 Pages) Tyco Electronics – Insulated tap assemblies include a housing for protection from other components on the pc board.

Installation and Removal
of Power Tap Assemblies
(with Eye-of-the-Needle Contacts)
Housing
Instruction Sheet
408-10260
12 JAN 09 Rev A
6-Position
Power Tap Assembly
Stand-Off
(4) Places
10-Position
Power Tap Assembly
Contacts
Straddle Mount
10-Position
Power Tap Assembly
NOTE: Mounting Screw and Washer(s) Not Supplied by Tyco Electronics
PROFILE
PART NUMBER
NUMBER OF
POSITIONS (Contacts)
CENTERLINE SPACING
mm [in.]
Standard
2057292-1
2057293-1
6
3.18 X 6.35 [.125 X .250]
10
3.18 X 6.35 [.125 X .250]
Straddle Mount
2057294-1
10
3.0 X 11.0 [.118 X .433]
Figure 1
1. INTRODUCTION
The Power Tap Assemblies (with Eye–of–the–Needle
Contacts ) listed in Figure 1 are designed to be
mounted onto a printed circuit (pc) board to provide
high current to the pc board. The taps can also be
connected to a bus bar or terminal. Read these
instructions thoroughly before installing any tap
assemblies.
The tap or housing has standoffs that are used for
inspection of proper seating on the pc board.
3. TOOLING
Customer supplied tooling for seating the Power Tap
Assemblies shall be designed using the dimensions
provided in Figures 2 and 3.
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures are
for reference only and are not drawn to scale.
NOTE
i
Make sure that the front and the sides of the
support block are parallel when installed in power
unit.
2. DESCRIPTION (Figure 1)
Each tap assembly features a tap with six or ten
contacts. A screw is NOT included with the tap
assemblies.
Insulated tap assemblies include a housing for
protection from other components on the pc board.
Power for seating taps must be provided by
application tooling capable of supplying a downward
force of 1780 Newtons (N) [400 lb]. The power unit
must have sufficient throat depth to accommodate
various positions on the pc board. In addition, the
power unit must have provision for ram adjustment to
prevent under– or over–insertion.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 3
LOC B