408-10236 Datasheet, PDF (1/3 Pages) Tyco Electronics – The seating tool consists of an adapter, a signal contact blade, and a power contact blade.

Seating Tool Assembly 91360-1
For Z-PACK* 2mm Hard Metric (HM)
Type M Vertical Male Connector Assembly
Seating Tool Assembly
Adapter
Instruction Sheet
408-10236
21 JUL 08 Rev A
ACTION PIN*
Contact
Signal Contact
Blade
Power Contact
Blade
Z-PACK 2mm HM Type M
Vertical Male Connector
Assembly 646709-1 (Ref)
Printed Circuit (PC)
Board
PC Board Support Fixture
(Customer Designed)
Figure 1
1. INTRODUCTION
Seating Tool Assembly 91360–1 is used to seat
Z–PACK 2mm HM Type M vertical male connector
assemblies with ACTION PIN contacts to allow
solderless pc board installation. The seating tool is
specifically designed for the number of positions in
the connector. Refer to Figure 1. Read these
instructions thoroughly before using the seating tool.
NOTE
i
All numerical values in this instruction sheet are
in metric units [with U.S. customary units in
brackets]. Dimensions are in millimeters [and
inches]. Figures are not drawn to scale.
the contacts from pushing out of the housing. The
adapter presses on the top surface of the connector
when the applicator ram applies force to the seating
tool.
3. REQUIREMENTS
3.1. PC Board Support Fixture
A fixture must be used to provide proper support for
the pc board and alignment of the seating tool to the
contacts, and to protect the pc board and and
connector from damage. The pc board support fixture
must be designed for the specific needs according to
Instruction Sheet 408–6927.
2. DESCRIPTION
The seating tool consists of an adapter, a signal
contact blade, and a power contact blade.
During seating, the blades sit inside the connector
engaging the housing floor and contacts preventing
3.2. Application Tooling
Power for seating tools must be provided by a
machine capable of supplying a downward force of
133 Newtons (N) [30 lb] per contact. SM–3 Frame
Assembly 814700–[ ] (Customer Manual 409–5626
provides instructions) can be used.
E2008 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 3
LOC B