408-10176 Datasheet, PDF (1/3 Pages) Tyco Electronics – The tool consists of a head with a stationary die holder and moving die holder and handles with a ratchet.

CERTI-CRIMP* II Handle
Assembly for Large Dies
#16 AWG Max.
Instruction Sheet
408-10176
05 DEC 07 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Handles
Moving Die Holder
Head
Stationary Die Holder
Figure 1
1. INTRODUCTION
CERTI–CRIMP II Die Set Hand Tool 1901260–1 uses
interchangeable crimping dies and is used to crimp a
wide variety of products. These instructions are
general information only. Refer to the instruction
sheets packaged with the dies for specific crimping
instructions.
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures and
illustrations are for reference only and are not
drawn to scale.
2. DESCRIPTION (Figure 1)
CAUTION
!
The crimping dies bottom before the ratchet
releases. This feature ensures maximum
electrical and tensile performance of the crimp.
DO NOT re-adjust the ratchet.
Each set of dies consists of a moving die and a
stationary die. Most moving dies have square corners
and the stationary dies have chamfered corners. See
Figure 2. Exceptions to this feature will be shown on
the instruction sheet packaged with the dies.
Typical Crimping Dies
Moving Die
Locator
Insulation
Adjustment
Spacers
The tool consists of a head with a stationary die
holder and moving die holder and handles with a
ratchet.
Stationary
Die
This tool is a member of the CERTI–CRIMP II hand
crimping tool family. The ratchet on this tool ensures
full crimping of the product. Once engaged, the
ratchet will not release until the handles have been
FULLY closed.
E2007 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
Die Holding Screw
Figure 2
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 3
LOC B