408-10120 Datasheet, PDF (1/5 Pages) Tyco Electronics – The die assembly features a wire anvil, an insulation anvil, a wire crimper, and an insulation crimper.

PRO-CRIMPER* III Hand
Tool Assembly 1976141-1
with Die Assembly 1976141-2
Instruction Sheet
408-10120
06 MAR 08 Rev B
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator Assembly
(Supplied with Die Assembly)
Stationary Jaw
Back of Tool (Wire Side)
Front of Tool (Locator Side)
Pivot Pin
Die Assembly
Moving Jaw
Ratchet Adjustment Wheel
The PRO-CRIMPER III Hand Tool is a Commercial" grade tool and is
designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate application specification, but may not comply with other feature
parameters of the specification. Tyco Electronics offers a variety of tools to
satisfy your performance requirements. For additional information, contact the
Tooling Assistance Center at 1-800-722-1111.
PRO-CRIMPER III Hand Tool
Frame 354940-1
(See Instruction Sheet 408-9930)
Stationary Handle
Moving Handle
DIE ASSEMBLY
PART NUMBER
{ ^{LOCATOR ASSY}
PART NUMBER
} ^CONTACT
FAMILY
SIZE
(mm² [AWG])
WIRE
INSUL DIA.
mm [in.] Max.
STRIP LENGTH
mm [in.]
1976141-2
58515-1
MOLEX
Mini-Fit Jr.
0.35-0.08
[22-28]
1.80
[.071]
2.79-3.30
[.110-.130]
{ } Supplied with die assembly, also available separately. Contact the Tooling Assistance Center number at the bottom of this page
for specific contact part numbers.
Figure 1
1. INTRODUCTION
PRO–CRIMPER III Hand Tool Assembly 1976141–1
consists of Die Assembly 1976141–2 and
PRO–CRIMPER III Hand Tool Frame 354940–1. The
die assembly consists of crimping dies and a locator
assembly. See Figure 1. Read these instructions
thoroughly before crimping any contacts.
adjustable ratchet that ensures full contact crimping.
The tool frame holds a die assembly with two
crimping sections.
The die assembly features a wire anvil, an insulation
anvil, a wire crimper, and an insulation crimper.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for reference only, and are
not drawn to scale.
2. DESCRIPTION
The tool features a tool frame with a stationary jaw
and handle, a moving jaw, a moving handle, and an
Attached to the outside of the frame is a locator
assembly, which contains a locator, a spring retainer,
and a contact support.
Die retaining pins and die retaining screws are used
to position and secure the dies in the tool frame. A
nut is used on the upper die retaining screw to hold
the locator assembly in place.
E2008 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B