408-10057 Datasheet, PDF (1/2 Pages) Tyco Electronics – Press down evenly on the extraction tool until it bottoms on the chicklet

Extraction Tools 1804175- 1, 1804176- 1, and
1804177- 1 for Chicklets of Z- PACK*
Hard Metric (HM)- Zd Right- Angle Headers
Instruction Sheet
408- 10057
10 SEP 09 Rev B
Insertion
Leg
Support
Leg
EXTRACTION TOOL
RIGHT- ANGLE HEADER
1804175--1
2--Pair
1804176--1
3--Pair
1804177--1
4--Pair
Figure 1
1. INTRODUCTION
The extraction tools listed in Figure 1 are designed to
remove individual chicklets of Z--PACK HM--Zd
right--angle headers from the printed circuit (pc)
board.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
2. DESCRIPTION
Each extraction tool features an insertion leg with a
slot designed to straddle the row of contacts, and a
support leg that supports the back of the chicklet
during extraction.
3. Press down evenly on the extraction tool until it
bottoms on the chicklet. Make sure that the row of
contacts enters the slot of the insertion leg.
4. Hold onto the pc board, and gently rock the
extraction tool toward the front of the chicklet,
creating interference (the chicklet will pivot out
slightly).
NOTE
i
DO NOT try to pull the chicklet straight off of the
pc board; otherwise, the extraction tool will slip
off of the chicklet.
5. Continue to rock the extraction tool back--and--
forth until the chicklet lifts away from the pc board.
6. Discard the chicklet.
Detail A
Slot of
Insertion Leg
Row of
Contacts
Press Down
Back of
Chicklet
Detail B
PC Board
Rock Extraction Tool Back- and- Forth
3. EXTRACTION PROCEDURE
1. Refer to instruction sheet 408--10055, and
remove the housing from the pc board.
NOTE
i
The housing of the right- angle header must be
removed from the pc board before the chicklets
can be removed.
Insertion Tool
Bottomed on
Chicklet
2. Position the extraction tool over the chicklet to
be removed so that the support leg is aligned with
the back of the chicklet and the row of contacts will
enter the slot of the insertion leg. See Figure 2,
Detail A.
Figure 2
E2009 Tyco Electronics Corporation, Harrisburg, PA TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All International Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 2
LOC B