408-10055 Datasheet, PDF (1/2 Pages) Tyco Electronics – Reasons for reissue of this instruction sheet are provided in Section 7, REVISION SUMMARY

Removal Tools 1804171- 1, 1804173- 1, and
1804174- 1 for Housing of Z- PACK*
Hard Metric (HM)- Zd Right- Angle Headers
Instruction Sheet
408- 10055
10 SEP 09 Rev B
Thumbscrew
Knob
Pusher
(2 Places)
Release
Block
Puller
Lever Arm
(2 Places)
Lever
REMOVAL TOOL
1804171--1
1804173--1
1804174--1
RIGHT- ANGLE HEADER
2--Pair
3--Pair
4--Pair
Figure 1
1. INTRODUCTION
The removal tools listed in Figure 1 are designed to
remove the housing from the chicklets of Z--PACK
HM--Zd right--angle headers. The chicklets will remain
on the printed circuit (pc) board.
Reasons for reissue of this instruction sheet are
provided in Section 7, REVISION SUMMARY.
2. DESCRIPTION
Each removal tool consists of the components shown
in Figure 1. After the release block is attached to the
front of the header, the thumbscrew knob is used to
secure the puller to the housing. Rotating the lever
moves the pushers against the pc board and pulls the
housing from the header.
3. ADJUSTMENT
Before using the removal tool, each pusher must be
positioned according to the location of the header on
the pc board. Refer to Figure 2.
CAUTION
!
To avoid damage to the header or pc board,
make sure that the pushers are properly
positioned before using the removal tool.
If adjusting both pushers, pull the other lever arm,
with the lever attached, from the groove pin.
2. Flip the pusher(s) so that either the
longer--length end (standard position, shown in
Figure 2) or shorter--length end (reversed position)
faces the front of the removal tool. For the
standard position, make sure that the indent of the
pusher faces outward. Refer to Figure 2.
3. Place the hole of the lever arm onto the groove
pin, and place the dowel pin of the lever arm into
the hole (of the pusher) closest to back of removal
tool. Refer to Figure 2.
If adjusting both pushers, do the same for the other
lever arm (with the lever attached).
4. Secure the lever arm to the lever with the
screws.
Groove
Pin
Longer- Length
End of Pusher
Dowel
Pin
Lever
Arm
Screws
Indent
Front of
Removal Tool
Shorter- Length
Hole
End of Pusher
HEADER
LOCATION
Single
Right End of Stack
Left End of Stack
Middle of Stack
LEFT PUSHER
POSITION
Standard
Reversed
Standard
Reversed
Figure 2
RIGHT PUSHER
POSITION
Standard
Standard
Reversed
Reversed
Adjust the pusher(s) as follows:
1. Remove the screws that secure the lever arm
(to be adjusted) onto the lever. Pull the lever arm
from the groove pin. See Figure 2.
4. REMOVAL PROCEDURE
1. Loosen, but do not remove, the thumbscrew so
that the puller can be positioned at an angle. See
Figure 3, Detail A.
E2009 Tyco Electronics Corporation, Harrisburg, PA TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All International Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 2
LOC B