408-10034 Datasheet, PDF (1/5 Pages) Tyco Electronics – The crimping head consists of integral jaws which close in an arc-like motion.

Crimp Head
Mounting Holes
SOLISTRAND* and STRATO- THERM*
Crimping Heads Used with Double Action
Battery Powered Hand Tool Kits 1213804- [ ]
Battery Powered
Crimp Tool
Battery
Lock
Instruction Sheet
408-10034
28 OCT 10 Rev B
Retract Button
DAHT Adapter
Assembly
2-Crimping
Chambers
3-Crimping
Chambers
Battery
Cartridge
1725839-1
Typical DAHT
Crimp Head (Ref)
Quick-Release Pins
Figure 1
1. INTRODUCTION
Crimping Heads 1-46447-0, 1-69363-0 and
1-49935-0 are designed to crimp SOLISTRAND and
STRATO-THERM Terminals and Splices, and
PLASTI-GRIP* Terminals and Splices onto solid or
stranded copper wire size 26-10 AWG. Refer to
Figure 2. The crimping heads are used with Double
Action Battery Powered Hand Tool Kits 1213804-[ ].
NOTE
i
The crimping heads can also be used with the 626
Double Action Pneumatic Tool Adapter 1213563-1.
This instruction sheet provides recommended
procedures for wire preparation, crimping head
installation, crimping, and maintenance and
inspection. For information concerning tool setup and
operation, refer to Customer Manual 409-10056
packaged with the battery tool kit.
NOTE
i
Dimensions are in metric units with [inches in
brackets]. Figures and illustrations are for
reference only and are not drawn to scale.
Reasons for reissue are provided in Section 8,
REVISION SUMMARY.
2. DESCRIPTION
The crimping head consists of integral jaws which
close in an arc-like motion. After an operator locates
the terminal or splice between the crimping jaws and
inserts the stripped wire, the tool is activated to crimp
the terminal or splice to the wire.
3. HEAD INSTALLATION AND REMOVAL
NOTE
i
Crimping heads are coated with a preservative to
prevent rust and corrosion. Wipe this preservative
from the head, particularly from the crimping
surfaces.
3.1. Installation
DANGER
STOP
To avoid personal injury, be sure to exercise
extreme caution when handling the crimp tool.
Avoid accidentally depressing the trigger control
when installing or removing crimp heads.
DANGER
STOP
DO NOT operate the battery tool without the proper
crimping head installed. After crimping head is
installed, make sure that the quick pins are properly
inserted to avoid personal injury and damage to the
tool.
©2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B