408-10033 Datasheet, PDF (1/6 Pages) Tyco Electronics – Reasons for reissue are provided in Section 8, REVISION SUMMARY.

STRATO- THERM* Crimping Heads
Used with Double Action Battery
Powered Hand Tool Kits 1213804- [ ]
-
Battery Powered Battery
Crimp Tool
Lock
Retract Button
Crimp Head
Mounting Holes
DAHT Adapter
Assembly
Instruction Sheet
408- 10033
29 NOV 10 Rev B
Battery
Cartridge
1725839- 1
Typical DAHT
Crimp Head (Ref)
Quick- Release
Pins
Figure 1
1. INTRODUCTION
Crimping Heads 1--46673--0, 1--46673--1, and
1--46988--0 are designed to crimp STRATO--THERM
Terminals and Splices onto wire size 26--14 AWG.
Refer to Figure 2. The crimping heads are used with
Double Action Battery Powered Hand Tool Kits
1213804--[ ].
NOTE
i
The crimping heads can also be used with the
626 Double Action Pneumatic Tool Adapter
1213563- 1.
This instruction sheet provides recommended
procedures for wire preparation, crimping head
installation, crimping, and maintenance and
inspection. For information concerning tool setup and
operation, refer to Customer Manual 409--10056
packaged with the battery tool kit.
NOTE
i
Dimensions are in metric units with [inches in
brackets]. Figures and illustrations are for
reference only and are not drawn to scale.
Reasons for reissue are provided in Section 8,
REVISION SUMMARY.
2. DESCRIPTION
The crimping head consists of integral jaws which
close in an arc--like motion. After an operator locates
the terminal or splice between the crimping jaws and
inserts the stripped wire, the tool is activated to crimp
the terminal or splice to the wire.
E2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other product names, logos, or company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 6
LOC B