English
Language : 

4-5435166-9 Datasheet, PDF (1/7 Pages) Tyco Electronics – Dual In- Line Package (DIP) Programming Switches
Dual In- Line Package (DIP)
Programming Switches
(7000 and 7100 Series)
Application Specification
114- 1056
03 MAY 11 Rev D
NOTE
i
All numerical values are in metric units [with U.S. customary units in brackets]. Dimensions are in millimeters [and
inches]. Unless otherwise specified, dimensions have a tolerance of +0.13 [+.005] and angles have a tolerance of +2_.
Figures and illustrations are for identification only and are not drawn to scale.
1. INTRODUCTION
This specification covers the requirements for application of DIP programming switches (7000 and 7100
Series) for printed circuit (pc) board applications. 7000 Series switches are designed for a life of 7,000 cycles
per pole. 7100 Series switches are recommended for programming applications where the number of cycles is
limited to 2,000 per pole.
Switches are manually rocker actuated and are designed for wave soldering on printed circuit (pc) boards or
insertion into DIP Sockets with in--row centerline spacing of 7.62 [.300]. 7000 series switches are black, and
are available in 2 through 12 positions, while 7100 series switches are blue and available in 2 through 12
positions. Both series are available with a premium seal, an economy seal, or unsealed in the raised rocker
(standard profile) or flush rocker profile (low profile). In addition, 7000 series switches are available with a side
rocker profile (side actuated). Both series are individual single--pole, single--throw (SPST). 7000 series raised
rocker profile switches may have ganged rockers for single--pole, double--throw (SPDT) and double--pole,
double--throw (DPDT) make--before--break circuits.
The unsealed switches are designed for socket applications and the sealed switches are designed for soldering
directly to the pc board. The sealants prevent flux and other contaminants from entering the switch during
soldering and cleaning. The raised rocker and side rocker profiles come unsealed or with an optional economy
or premium masking top seal. The flush rocker profile comes unsealed or with an optional economy tape top
seal or premium masking top seal. The multi--pole switches come unsealed only. All switches come standard
with a bottom seal. Switches are designed for use in logic level switching applications.
When corresponding with personnel, use the terminology provided in this specification to facilitate your
inquiries for information. Basic terms and features of this product are provided in Figure 1.
Standard Profile Switch
Raised Rocker
Low- Profile Switch
Position
Number
Flush Rocker
White Dot Identifies Pin 1
Side Rocker Switch
Housing
White Dot Identifies Pin 1
Figure 1
Solder Tail
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1--800--722--1111 This controlled document is subject to change.
PRODUCT INFORMATION 1--800--522--6752
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 7
LOC B