3VSK1 Datasheet, PDF (1/4 Pages) Tyco Electronics – 3 to 40 Amp High Performance K Series RFI Power Line Filters for SMPS Emission Control

SK Series
CORCOM Product Guide
3 to 40 Amp High Performance K Series RFI Power Line Filters
for SMPS Emission Control
UL Recognized
CSA Certified
VDE Approved
SK7
SK1
SK3
SK Series
This series of RFI filters was designed to reduce conducted
noise to acceptable limits for equipment that must comply
with the FCC specifications in the USA and CISPR
specifications in Europe.
The SK (Super K) series filters use significantly higher
element values than the general purpose K series, which
makes them better suited for equipment with line-to-ground
and line-to-line conducted emissions, including switch
mode power supplies.
The ESK models meet the very low leakage current
requirements of VDE portable equipment and (120 Volt)
UL 544 non-patient medical equipment.
Models ESK6C and VSK6C additionally incorporate a
separate ground-circuit inductor to isolate the equipment
chassis from power line ground at RF frequencies.
Specifications
Maximum leakage current,each line-to-ground
VSK Models
3, 6 & 10 Amps
@ 120 VAC 60 Hz:
.4 mA
@ 250 VAC 50 Hz:
.7 mA
20, 30 & 40 Amps
@120 VAC 60 Hz:
.75 mA
@250 VAC 50 Hz:
Hipot rating (one minute):
1.25 mA
line-to-ground
line-to-line
Operating frequency:
Rated voltage (max.):
Rated current:
3VSK/3ESK
6VSK/6ESK
10VSK/10ESK
20VSK/20ESK
30VSK/30ESK
40VSK
ESK Models
.21 mA
.36 mA
.3 mA
.5 mA
2250 VDC
1450 VDC
50/60 Hz
250 VAC
3A
6A
10A
20A
30A
40A
Electrical Schematic
LINE
6C models
only
Resistor location for reference only.
LOAD
88
Catalog 1654001
Revised 05-07
Dimensions are in inches and
millimeters unless otherwise
specified. Values in italics
are metric equivalents.
Dimensions are shown for
reference purposes only.
Specifications subject
to change.
USA Cust. Svc.: 1-800-468-2023
CORCOM Prods: 1-847-680-7400
Germany:
49-89-6089-0
www.corcom.com
www.tycoelectronics.com