220015-3 Datasheet, PDF(1/6 Page) Tyco Electronics – Heavy Head Hand Crimping Tools (HHHT)

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

220015-3 Datasheet, PDF (1/6 Pages) Tyco Electronics – Heavy Head Hand Crimping Tools (HHHT)

Heavy Head Hand Crimping

Tools (HHHT) 220015-[ ]

Instruction Sheet

408-2331

19 APR 12 Rev C

PROPER USE GUIDELINES

Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use

and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.

Adjustment Cap

Front of Tool

CERTI-CRIMP*

Hand Crimping Tool

Ratchet Control

Integral Crimping Dies

Ferrule

Crimping Area

Right Side

of Tool

Center Contact

Crimping Area

Figure 1

1. INTRODUCTION

This instruction sheet covers application and

maintenance procedures for Heavy Head Hand

Crimping Tools 220015-[ ]. Refer to Figure 1. The hand

tools are used to crimp a variety of coaxial connectors

with flexible cable. For applicable connector part

numbers and corresponding cable sizes, refer to

Catalog 1307191. Information pertaining to the

connectors (cable stripping dimensions and assembly

of component parts) is included in instructions

packaged with the connectors. Read all instructions

thoroughly before proceeding.

NOTE

Dimensions on this sheet are in metric units

[followed by U.S. customary units in brackets].

Figures and illustrations are for identification only

and are not drawn to scale.

Reasons for reissue are provided in Section 6,

REVISION SUMMARY.

2. DESCRIPTION

Each tool features integral dies that have two crimping

areas (one to crimp the center contact, and one to

crimp the ferrule), an adjustment cap that rotates the

locator-stop (as required), and a CERTI-CRIMP hand

crimping tool ratchet control which ensures full

crimping. Once engaged, the ratchet will not release

until the tool handles have been FULLY closed.

The FRONT of the tool is marked with the part

number. The center contact enters the crimping area

from the RIGHT side of the tool. The contact/cable

assembly is inserted through the BACK of the tool for

ferrule crimping.

3. ASSEMBLY AND CRIMPING PROCEDURES

Select the appropriate cable and connector for the

tool. Slip ferrule over cable; then strip cable to the

proper length, according to instructions packaged with

the connector (plug or jack).

3.1. Crimping the Center Contact

Refer to Figure 2 and proceed as follows:

1. Determine contact type (long or short) from the

dimensions provided in Figure 2. Rotate locator/

stop by turning adjustment cap to OPEN position for

long-type contacts, or CLOSED position for short-

type contacts.

*Trademark

TOOLING ASSISTANCE CENTER 1-800-722-1111

PRODUCT INFORMATION 1-800-522-6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.te.com

TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or company names may be trademarks of their respective owners.

1 of 6

▷