2-1194946-2 Datasheet, PDF (1/1 Pages) Tyco Electronics – SOLDERSLEEVE WIRE TERMINATOR

SPECIFICATION CONTROL DRAWING
MATERIALS
1. INSULATION SLEEVE: Heat shrinkable, transparent blue, radiation cross-linked polyvinylidene
fluoride.
2. SOLDER PREFORM WITH FLUX:
SOLDER: TYPE Sn63 per ANSI J-STD-006.
FLUX: TYPE ROL1 per ANSI J-STD-004.
APPLICATION
1. This part is designed to attach a tin or silver plated wire to terminals with 2.54 (0.100) or greater
center spacing.
Wire Accommodation:
Jacket O.D.: 0.76 to 2.03 (0.030 to 0.080)
Gauge: AWG 26 to 20
Connector Terminal:
Max. Diagonal: 0.76 (0.030)
Height: 5.08 to 7.62 (0.200 to 0.300)
2. Sleeve will recover to 0.76 (0.030) max. I.D.
3. This drawing forms part of Raychem Specification control Drawing:
D-711-04, 2.54 (0.100) centers
D-711-07, 3.18 (0.125) centers
D-711-08, 3.96 (0.156) centers
Tyco Electronics Corporation
300 Constitutional Drive
Menlo Park, CA 94025 USA
UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS.
INCHES DIMENSIONS ARE BETWEEN BRACKETS.
TITLE:
SOLDERSLEEVE WIRE
TERMINATOR
DOCUMENT NO.: D-141-31
TOLERANCES:
0.00 N/A
0.0 N/A
0 N/A
ANGLES: N/A
ROUGHNESS IN
MICRON
Tyco reserves the right to amend this
drawing at any time. Users should evaluate
the suitability of the product for their
application.
DATE:
17-July-00
DRAWN BY:
M. FORONDA
CAGE CODE:
06090
REPLACES:
N/A
DCR NUMBER:
D000398
PROD. REV.:
E
SCALE:
None
If this document is printed it becomes uncontrolled. Check for the latest revision.
DOC ISSUE:
1
SIZE:
A
SHEET:
1 of 1