2-1193344-8 Datasheet, PDF (1/1 Pages) Tyco Electronics – FOUR CONDUCTOR CABLE, UNSHIELDED, UNJACKETED, GENERAL PURPOSE, 600 VOLT

SPECIFICATION CONTROL DRAWING
TITLE
Date
FOUR CONDUCTOR CABLE, UNSHIELDED, UNJACKETED, GENERAL PURPOSE, 600 VOLT
8-26-09
This specification sheet forms a part of the latest issue of Raychem Specification 55A.
COMPONENT WIRES - 55A0111
55A0141
Revision
D
PART NUMBER
1/
55A0141-30-*
55A0141-28-*
55A0141-26-*
55A0141-24-*
55A0141-22-*
55A0141-20-*
55A0141-18-*
55A0141-16-*
55A0141-14-*
55A0141-12-*
CABLE CONSTRUCTION DETAILS
CONDUCTOR
SIZE
(AWG)
OUTSIDE DIAMETER
(inches)
NOMINAL
MAXIMUM
30
.058
.071
28
.065
.079
26
.077
.093
24
.090
.106
22
.104
.123
20
.121
.142
18
.145
.169
16
.165
.191
14
.206
.240
12
.249
.289
CABLE RATINGS AND ADDITIONAL REQUIREMENTS
MAXIMUM
WEIGHT
(lbs/1000 ft.)
2.7
3.7
5.7
8.2
11.4
17.5
26.5
33.9
53.0
80.4
TEMPERATURE RATING: 150°C
Maximum continuous conductor temperature
VOLTAGE RATING: 600 volts (rms) at sea level
INSULATION FLAWS:
Spark Test, 5.7 kV (rms) at 3 kHz
Impulse Dielectric Test, 8.0 kV (peak)
PART NUMBER:
The “*” in the part numbers above shall be replaced by color
code designators with a slash separating the component wire
colors. Colors shown do not necessarily reflect the sequence
of manufacturing.
1/ Example: AWG 22, black, brown, red and orange
component wires: 55A0141-22-0/1/2/3
NOTE: Nominal values are for information only.
Nominal values are not requirements.
Users should evaluate the suitability of this product for their application. Specifications are subject to change without notice.
Tyco Electronics also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer.
1/ COLORS AND COLOR CODE DESIGNATORS SHALL BE IN ACCORDANCE WITH MIL-STD-681. HOWEVER, DUE TO LENGTH LIMITATIONS OF THE RAYCHEM PART NUMBER,
AN ALTERNATIVE COLOR CODE MAY REPLACE MIL-STD-681 COLOR CODE DESIGNATORS. (EXAMPLE: “901/902...” MAY BE REPLACED BY “Axxx”.) OTHER CODES AND
SUFFIXES MAY BE ADDED TO THE PART NUMBER AS NECESSARY, TO CAPTURE ANY ADDITIONAL REQUIREMENTS IMPOSED BY THE PURCHASE ORDER.
Page 1 of 1
The TE logo, Tyco Electronics and Raychem are trademarks.
DIMENSIONS ARE IN INCHES, AND UNLESS OTHERWISE DESIGNATED ARE NOMINAL
THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN.
REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON DATE OF INVITATION FOR BID.
Raychem Wire & Cable
501 Oakside Avenue
Redwood City, CA 94063-3800
Phone: [phone]
Fax: [phone]
© 2006-2009 Tyco Electronics Corporation. All rights reserved.