114-13164 Datasheet, PDF (1/11 Pages) Tyco Electronics – When corresponding with personnel, use the terminology provided in this specification to facilitate your inquiries for information.

Multi-Beam XL
Cable Plug Assemblies
Application Specification
114-13164
05 JUN 07
Rev D
NOTE
i
_ ^{All numerical values are in metric units [with U.S. customary units in brackets]. Dimensions are in millimeters [and}
inches]. Unless otherwise specified, dimensions have a tolerance of +0.13 [+.005] and angles have a tolerance of +2 .
Figures and illustrations are for identification only and are not drawn to scale.
1. INTRODUCTION
This specification covers the requirements for application of Multi–Beam XL cable plug assemblies used in
power distribution systems. The cable plugs are available in floating panel–mount and slide–to–lock for
panel–mount applications and squeeze–to–release for free–hanging applications. The cable plugs are supplied
fully assembled with terminated contacts.
NOTE
The amount and location of power and signal contacts is customer determined. Different cable plug configurations can
be designed to meet customer requirements within the limitations stated in this document.
When corresponding with personnel, use the terminology provided in this specification to facilitate your
inquiries for information. Basic terms and features of this product are provided in Figure 1.
Floating Panel-Mount Cable Plug
(2P + 24S + 2P)
Panel Stop
Panel Alignment
Key
Housing
Wires
Slide-to-Lock Cable Plug
(3 ACP)
Panel Stop
Wires
Panel Alignment
Key (2 Places)
Housing
Shoulder
Guide Hole
(2 Places)
Power
Circuitry
Signal
Circuitry
Mounting Hole
(2 Places)
Guide Hole
(2 Places)
Power
Circuitry
Squeeze-to-Release Cable Plug
(2P + 24S + 2P)
Housing
Spring
Latch
Wires
Locking
Tab
Mating Alignment
Key (2 Places)
Power
Circuitry
Signal
Circuitry
Squeeze Latch
(2 Places)
NOTE: `P' stands for power circuitry with contact centerline spacing of 6.35 [.250], `S' stands for signal contacts, `ACP' stands for power circuitry with
contact centerline spacing of 7.62 [.300], `and HDP' stands for high density power circuitry with contact centerline spacing of 5.08 [.200].
Figure 1
E2007 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 11
LOC B