114-13121 Datasheet, PDF (1/10 Pages) Tyco Electronics – Small Form-Factor Pluggable (SFP) Ganged Press-Fit PT Connector and Cage Assembly

Small Form-Factor Pluggable (SFP)
Ganged Press-Fit PT Connector
and Cage Assembly
Application Specification
114-13121
26 JAN 06 Rev A
NOTE
_ ^{All numerical values are in metric units [with U.S. customary units in brackets]. Dimensions are in millimeters. Unless}
otherwise specified, dimensions have a tolerance of +0.13 and angles have a tolerance of +2 . Figures and
illustrations are for identification only and are not drawn to scale.
1. INTRODUCTION
This specification covers the requirements for application of SFP Ganged Press–Fit PT Connector and Cage
  ^{Assembly to interconnect fiber optic or copper transceiver modules to printed circuit (pc) boards. The}
connector with cage assembly is one unit available in a 1 4 and 1 6 configuration. The connector and the
cage assembly are also available separately for rework purposes.
The connector consists of a housing with a 20–position receptacle port and compliant pin contacts on 0.8
centerline spacing. The housing features alignment posts that provide stability for placement on the pc board.
Each receptacle port has a card entry slot that accepts a 1.0+0.1 thick integrated circuit card housed in the
mating module.
The cage assembly is a frame with compliant pin contacts for mechanical retention to the pc board and to
provide electromagnetic interference (EMI) suppression, thermal vent holes, and panel ground springs. The
cage assembly features a locking latch and a kick–out spring for each mating module. The locking latch holds
the module in place, and the kick–out spring releases the module for removal. A dust cover (for each port) is
used when the module is not mated to the cage assembly to prevent contaminants from entering the chassis.
The cage assembly is designed to be inserted into a bezel after being seated onto the pc board.
When corresponding with Tyco Electronics Personnel, use the terminology provided in this specification to
facilitate your inquiries for information. Basic terms and features of this product are provided in Figure 1.
Connector With Cage Assembly
Dust Cover
Cage Assembly
Connector (4 Places)
1 6 Configuration
1 4 Configuration
Cage Assembly
Figure 1 (cont’d)
Connector (6 Places)
E2006 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
Tyco is a trademark. *Trademark
Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 10
LOC B