SW05-0311 Datasheet, PDF (3/4 Pages) Tyco Electronics – Match GaAs SPST Switch, DC - 3 GHz with TTL/CMOS Control Input

SW05-0311
Matched GaAs SPST Switch,
DC-3.0 GHz with TTL/CMOS Control Input
Absolute Maximum Ratings ^3,4
Parameter
Max Input Power
50 MHz
500 - 3000 MHz
V_CC
V_EE
V_CC - V_EE
Vin⁵
Operating Temperature
Storage Temperature
Absolute Maximum
+27 dBm
+34 dBm
-0.5V ≤ V_CC ≤ +7.0V
-8.5V ≤ V_EE ≤ +0.5V
-0.5V ≤ V_CC - V_EE ≤ 14.5V
-0.5V ≤ Vin ≤ V_CC + 0.5V
-40°C to +125°C
-65°C to +150°C
3. Exceeding any one or combination of these limits may cause
permanent damage to this device.
4. M/A-COM does not recommend sustained operation near
these survivability limits.
5. Standard CMOS TTL interface, latch-up will occur if logic
signal is applied prior to power supply.
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
Gallium Arsenide Integrated Circuits are sensitive
to electrostatic discharge (ESD) and can be
damaged by static electricity. Proper ESD control
techniques should be used when handling these
devices.
Rev. V6
Truth Table (Switch)
Control Input
C1
0
1
Condition of Switch
RF1 to RF2
ON
OFF
0 = TTL Low; 1 = TTL High
Typical Performance Curves
Insertion Loss vs. Frequency
+ 8 5 °C
+ 2 5 °C
2
- 55 °C
1.5
1
0.5
0
0 .0
0 .5
1.0
1.5
2.0
2.5
3
F requency (GH z)
Isolation vs. Frequency
VSWR vs. Frequency
80
70
60
50
40
30
20
10
0
0 .0
0 .5
1.0
1.5
2.0
2.5
3
F requency (GH z)
2.00
1.80
1.60
1.40
1.20
1.00
0.0
V SWR On
V SWR Off
0.5
1.0
1.5
2.0
2.5
3
Frequency (GH z)
3
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] • Europe Tel: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: [phone]
• China Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.