AT-263-PIN_15 Datasheet, PDF (3/4 Pages) M/A-COM Technology Solutions, Inc. – Digital Attenuator

AT-263-PIN
Digital Attenuator
31.0 dB, 5-Bit, TTL Driver, DC-2.0 GHz
Absolute Maximum Ratings ^3,4
Parameter
Absolute Maximum
Max Input Power
0.05 GHz
0.5 - 2.0 GHz
+27 dBm
+34 dBm
V_CC
V_EE
V_CC - V_EE
Vin⁵
Operating Temperature
-0.5V ≤ V_CC ≤ +7.0V
-8.5V ≤ V_EE ≤ +0.5V
-0.5V ≤ V_CC - V_EE ≤ 14.5V
-0.5V ≤ Vin ≤ V_CC + 0.5V
-55°C to +125°C
Storage Temperature
-65°C to +150°C
3. Exceeding any one or combination of these limits may cause
permanent damage to this device.
4. M/A-COM does not recommend sustained operation near
these survivability limits.
5. Standard CMOS TTL interface, latch-up will occur if logic
signal is applied prior to power supply.
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
Gallium Arsenide Integrated Circuits are sensitive
to electrostatic discharge (ESD) and can be
damaged by static electricity. Proper ESD control
techniques should be used when handling these
devices.
Rev. V6
Recommended PCB Configuration
Truth Table (Digital Attenuator)
Control Inputs
C5 C4 C3 C2 C1
0
0
0
0
0
0
0
0
0
1
0
0
0
1
0
0
0
1
0
0
0
1
0
0
0
1
0
0
0
0
1
1
1
1
1
0 = TTL Low; 1 = TTL High
Attenuation
Reference
1 dB
2 dB
4 dB
8 dB
16 dB
31 dB
3
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] • Europe Tel: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: [phone]
• China Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.