SW10-0312 Datasheet, PDF (2/4 Pages) Tyco Electronics – GaAs SPDT Reflective Switch, DC - 3 GHz with TTL/CMOS Control Input

SW10-0312
GaAs SPDT Reflective Switch,
DC-3.0 GHz with TTL/CMOS Control Input
Rev. V8
Electrical Specifications: T_A = +25°C^1,2
Parameter
Test Conditions
Frequency
Units
Insertion Loss
—
DC - 3000 MHz
dB
DC - 2000 MHz
dB
DC - 1000 MHz
dB
DC - 500 MHz
dB
VSWR
—
DC - 3000 MHz
Ratio
DC - 2000 MHz
Ratio
DC - 1000 MHz
Ratio
DC - 500 MHz
Ratio
Isolation
Trise, Tfall
Ton, Toff
—
DC - 3000 MHz
dB
DC - 2000 MHz
dB
DC - 1000 MHz
dB
DC - 500 MHz
dB
10% to 90%
—
ns
1.3V CTL to 90% / 10%
—
ns
Transients
In-Band
—
mV
1 dB Compression
IP2
Input Power
Two-Tone Input Power
up to +5 dBm
0.05 GHz
0.5 GHz to 3 GHz
0.05 GHz
0.5 GHz to 3 GHz
dBm
dBm
dBm
dBm
IP3
Vin Low
Vin High
Two-Tone Input Power
up to +5 dBm
0V to 0.8V
2.0V to 5.0V
0.05 GHz
0.5 GHz to 3 GHz
—
—
dBm
dBm
µA
µA
Vcc
+5.0V ± 10%
—
mA
Vee
-5.0V to -8.0V
—
mA
1. All specifications apply when operated with bias voltages of +5V for Vcc and –5V for Vee.
2. When DC blocks are used, a 10K ohm return to GND is required on the RFC port.
Min
—
—
—
—
—
—
—
—
27
30
35
40
—
—
—
—
—
—
—
—
—
—
—
—
—
Typ
0.9
0.8
0.7
0.6
1.4:1
1.3:1
1.2:1
1.1:1
36
38
42
45
50
150
50
+25
+30
+60
+65
+40
+46
—
—
—
—
Max
1.2
1.1
0.9
0.8
1.5:1
1.4:1
1.4:1
1.3:1
—
—
—
—
—
—
—
—
—
—
—
—
—
1
1
1
1
Absolute Maximum Ratings ^3,4
Parameter
Absolute Maximum
Max Input Power
50 MHz
500 - 3000 MHz
+27 dBm
+34 dBm
V_CC
V_EE
V_CC - V_EE
Vin⁵
Operating Temperature
-0.5V ≤ V_CC ≤ +7.0V
-8.5V ≤ V_EE ≤ +0.5V
-0.5V ≤ V_CC - V_EE ≤ 14.5V
-0.5V ≤ Vin ≤ V_CC + 0.5V
-40°C to +125°C
Storage Temperature
-65°C to +150°C
3. Exceeding any one or combination of these limits may cause
permanent damage to this device.
4. M/A-COM does not recommend sustained operation near
these survivability limits.
5. Standard CMOS TTL interface, latch-up will occur if logic
signal is applied prior to power supply.
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] • Europe Tel: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: [phone]
• China Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.