QH01-0016-G Datasheet, PDF (2/4 Pages) M/A-COM Technology Solutions, Inc. – Low Cost GMIC SMT Quad Hybrid 800 - 905 MHz

QH01-0016-G
Low Cost GMIC SMT Quad Hybrid
800 - 905 MHz
Electrical Specifications: T_A = 25°C, Z₀ = 50Ω
Parameter
Insertion Loss above 3.0 dB
Isolation
VSWR
Input
RF1, RF2 Outputs
Amplitude Balance
Phase Balance
Units
dB
dB
—
—
dB
Deg
Min
—
14
—
—
—
—
Typ
0.7
17
1.3:1
1.35:1
0.3
1.5
Rev. V3
Max
1.2
—
1.5:1
1.5:1
0.7
6
Absolute Maximum Ratings ^1,2
Parameter
Absolute Maximum
Input Power³
1 W CW
Operating Temperature
-40°C to +85°C
Storage Temperature
-65°C to +150°C
1. Exceeding any one or combination of these limits may cause
permanent damage to this device.
2. M/A-COM does not recommend sustained operation near
these survivability limits.
3. With internal load dissipation of 0.125 W Maximum.
Recommended PCB Configuration
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
GMIC Circuits are sensitive to electrostatic
discharge (ESD) and can be damaged by static
electricity. Proper ESD control techniques should
be used when handling these devices.
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] • Europe Tel: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: [phone]
• China Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.