MASW011021_15 Datasheet, PDF (2/5 Pages) M/A-COM Technology Solutions, Inc. – HMICTM Silicon PIN Diode SPDT Switch

MASW-011021
HMIC^TM Silicon PIN Diode SPDT Switch
6 - 14 GHz
Rev. V2
Electrical Specifications: Bias: -5 V, +30 mA, T_A = 25°C, P_IN = 0 dBm, Z₀ = 50 Ω
Parameter
Units
Min.
Typ.
Insertion Loss
8 GHz
10 GHz
12 GHz
—
0.70
dB
—
0.70
—
0.65
Input to Output Isolation
8 GHz
10 GHz
12 GHz
30
34
dB
30
36
30
34
Return Loss
IIP3
Switching Speed ³
Voltage Rating ⁴
CW Power Handling ⁵ (-30 V, +30 mA)
dB
—
15
dBm
—
60
ns
—
130
V
—
200
W
—
10
3. Typical Switching Speed measured for 10% to 90 % of detected RF signal driven by TTL compatible drivers.
4. Maximum reverse leakage current in either the shunt or series PIN diodes shall be 0.1 µA maximum.
5. 20 W up to 300 µs 40% Duty Cycle
Max.
0.85
0.85
0.85
—
—
—
—
—
—
—
—
Absolute Maximum Ratings^6,7
Parameter
Absolute Maximum
Operating Temperature
Storage Temperature
-65°C to +125°C
-65°C to +150°C
Junction Temperature
Applied Reverse Voltage
+175°C
200 V
Bias Current +25°C
100 mA
6. Exceeding any one or combination of these limits may cause
permanent damage to this device.
7. M/A-COM Technology Solutions does not recommend
sustained operation near these survivability limits.
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
Silicon Integrated Circuits are sensitive to
electrostatic discharge (ESD) and can be damaged
by static electricity. Proper ESD control techniques
should be used when handling these Class 1A
HBM devices.
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] • Europe Tel: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: [phone]
• China Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.