MAIA-007495-000100_15 Datasheet, PDF (2/5 Pages) M/A-COM Technology Solutions, Inc. – Down Converter

MAIA-007495-000100
Down Converter
1500 — 2400 MHz
Rev. V1
Electrical Specifications: T_A = +25°C, Z₀=50 Ohms, RF = -10 dBm³,
LO = +13 dBm, I_DD ≈ 45 mA
Parameter
Conversion Gain ^8,9
Isolation ⁶
Reverse Isolation⁷
VSWR
Input IP3 ^3,4,5
Test Conditions³
LNA +3V
LNA +5V
LO to RF IN
LO to IF
LNA +3V
LO
RF IN
IF
LNA +3V
LNA +5V
Units
dB
dB
dB
dB
dB
Ratio
Ratio
Ratio
dBm
dBm
Min
3.1
4.6
29
19
30
—
—
—
13
21
Typ
6.0
8.0
32
23
40
1.4:1
1.9:1
1.9:1
17.5
25
3. For IP₃ measurements, RFIN = -24 dBm, this low RF IN level gets amplified through the LNA.
4. For IP₃ measurements, RFIN2 = RFIN1 + 10 MHz, LO = RFIN1—140 MHz.
5. For IP₃ measurements, IP3 = IMR/2 + PIN.
6. RF IN to IF Isolation is typically 0 dB.
7. Reverse Isolation is measured from IF to RFIN with the IF at –10 dBm, LO at +13 dBm.
8. The amplifier has a normal gain of 12.5 dB, 3V bias and 14.0 dB, 5V bias. Amplifier typical Noise Figure = 1.5 dB.
9. NF_T = NF₁ + (NF2 - 1)/G1
Max
6.6
8.8
—
—
—
—
2.5:1
2.1:1
—
—
Absolute Maximum Ratings ^10,11
Parameter
RF Input Power ¹²
LO Drive Power ¹²
V_DD
Current ¹³
Channel Temperature ¹⁴
Operating Temperature
Storage Temperature
Absolute Maximum
+17 dBm
+23 dBm
+10 VDC
80 mA
+150°C
-40°C to +85°C
-65°C to +150°C
10.Exceeding any one or combination of these limits may cause
permanent damage to this device.
11.M/A-COM does not recommend sustained operation near
these survivability limits.
12.Total power for RF and LO ports should not exceed +23 dBm.
13.When pin #2 is used to increase current—see note 8 above.
14.Thermal resistance (θjc) = +95°C/W.
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
Gallium Arsenide Integrated Circuits are sensitive
to electrostatic discharge (ESD) and can be
damaged by static electricity. Proper ESD control
techniques should be used when handling these
devices.
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] • Europe Tel: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: [phone]
• China Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.