MADR-007097_15 Datasheet, PDF (2/5 Pages) M/A-COM Technology Solutions, Inc. – SPDT PIN Diode Driver

MADR-007097
SPDT PIN Diode Driver
Rev. V3
Electrical Specifications: T_A = +25C, +Vcc = + Vdd = + 5.0V ± 5%, Vee = - 5.0V ±5%, Z₀ = 50
Parameter
Switching Speed ¹
Delay
Rt/Ft
PRF
Output Voltage Drop, No Load
DC Output Current
Peak Spike Output Current
Output Stage on Resistance
Quiescent Supply Currents
TTL Levels
Package Dissipation
Test Conditions
Spike current into 10 ohm load
50 % TTL to 90%
10%-90%; 90%-10%
50% duty cycle
With reference to supply voltage
Load Dependant
Spiking Capacitor in Circuit
Positive Output FET, Qp
Negative Output FET, Qn
+5V
-5V
Logic “0” @ 20 µA sink current
Logic “1” @ 20 µA source current
—
Units
ns
ns
MHz
V
mA
mA


mA
mA
V
V
mW
Min
—
—
DC
—
—
—
—
—
—
—
0
2.0
—
Typ
25
2
—
—
±30
±150
15
10
—
—
—
—
—
Max
35
5
5
0.25
±50
±200
20
15
1.5
.2
.8
5.0
200
1. Decoupling capacitors (.01 µF) are required on power supply lines.
Absolute Maximum Ratings ^2,3
Parameter
VCC
VDD
VEE
C1 (TTL Input Voltage)
Operating Temperature
Storage Temperature
Absolute Maximum
-0.5V ≤ VCC ≤ +7.0V
-0.5V ≤ VDD ≤ VCC
-7.0V ≤ VEE ≤ +0.5V
-0.5V to Vcc +0.5V
-40ºC to +85ºC
-65ºC to +125ºC
2. Exceeding any one or combination of these limits may cause
permanent damage to this device.
3. M/A-COM does not recommend sustained operation near
these survivability limits.
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
Silicon Integrated Circuits are sensitive to
electrostatic discharge (ESD) and can be damaged
by static electricity. Proper ESD control techniques
should be used when handling these devices.
2
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support