MAAL-010705 Datasheet, PDF (2/9 Pages) M/A-COM Technology Solutions, Inc. – Excellent Input Return Loss Integrated Active Bias Circuit

MAAL-010705
Low Noise Amplifier
0.5-1.6 GHz
Rev. V2
Electrical Specifications³: Freq = 0.9 GHz, Vd = 4 V, 25ºC, Z₀ = 50 
Parameter
Test Conditions
Units Min.
Typ.
Max.
Gain
-
dB
18
21
-
Output IP3
Pout=5 dBm, Tone Spacing=1 MHz dBm
-
32
-
Output P1dB
-
dBm
17.5
18.5
-
Input Return Loss
-
dB
-
19
-
Output Return Loss
-
dB
-
18
-
Noise Figure
-
dB
-
0.50
-
Total Current
IDQ=Id+IBias
mA
-
60
70
3. Vd and Vbias are connected together to +4 V, R3 = 150 ohms and R4 = 240 ohms, reference recommended schematic on page 8.
Absolute Maximum Ratings^4,5
Parameter
Absolute Max.
Supply Voltage
+5.5 V
Current
100 mA
Power Dissipation
600 mW
RF Input Power
20 dBm
Storage Temperature
-55 to +150 ºC
Operating Temperature
Junction Temperature⁶
-40 to +85 ºC
+150 ºC
4. Exceeding any one or combination of these limits may cause
permanent damage to this device.
5. M/A-COM Technology Solutions does not recommend
sustained operation near these survivability limits.
6. Typical thermal resistance (Өjc) = 45 °C/W.
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
Gallium Arsenide Integrated Circuits are sensitive
to electrostatic discharge (ESD) and can be
damaged by static electricity. Proper ESD control
techniques should be used when handling these
class 1A devices.
2
M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macomtech.com for additional data sheets and product information.
• North America Tel: [phone] / Fax: [phone]
• Europe Tel: [phone] / Fax: [phone]
• Asia/Pacific Tel: [phone] / Fax: [phone]