DS55-0004 Datasheet, PDF (2/3 Pages) Tyco Electronics – Low Cost Five-Way GMIC SMT Power Divider 824-896 MHz

DS55-0004
Low Cost Five-Way GMIC SMT Power Divider
824-896 MHz
Rev. V3
Electrical Specifications: T_A = +25°C, Z₀ = 50Ω
Parameter
Units
Min
Typ
Max
Insertion Loss
Isolation
Above 7.0dB
dB
—
0.7
1.2
dB
21
26
—
VSWR
Input
—
—
1.4:1
1.6:1
VSWR
Output
—
—
1.2:1
1.5:1
Amplitude Balance
dB
—
0.2
0.6
Phase Balance
°
—
5
10
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
GMIC Circuits are sensitive to electrostatic
discharge (ESD) and can be damaged by static
electricity. Proper ESD control techniques should
be used when handling these devices.
Typical Performance Curves
Insertion Loss vs. Frequency
(Dashed lines show amplitude balance window)
Absolute Maximum Ratings ^1,2
Parameter
Input Power³
Operating Temperature
Storage Temperature
Absolute Maximum
1 W CW
-40°C to +85°C
-65°C to +150°C
1. Exceeding any one or combination of these limits may cause
permanent damage to this device.
2. M/A-COM does not recommend sustained operation near
these survivability limits.
3. With Internal load dissipation of 0.125 W maximum.
VSWR vs. Frequency
Isolation vs. Frequency
Phase Balance vs. Frequency
(Relative RF1)
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] • Europe Tel: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: [phone]
• China Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.