DS54-0001 Datasheet, PDF (2/4 Pages) Tyco Electronics – Low Cost Four-Way SMT Power Splitter/Combiner, 824-960 MHz

DS54-0001
Low Cost Four-way SMT Power
Splitter/Combiner, 824 - 960 MHz
Rev. V5
Electrical Specifications: T_A = 25°C²
Parameter
Insertion Loss “above 6.0 dB theoretical loss”
Isolation
Input VSWR
Output VSWR
Amplitude Balance
Phase Balance
Frequency
824 - 960 MHz
824 - 960 MHz
824 - 960 MHz
824 - 960 MHz
824 - 960 MHz
824 - 960 MHz
2. All specifications apply with a 50-ohm source and load impedance.
Units
dB
dB
Ratio
Ratio
dB
Deg
Min
—
18
—
—
—
—
Typ
1.0
23
1.2:1
1.4:1
0.3
2
Max
1.2
—
1.4:1
1.75:1
0.7
4
Absolute Maximum Ratings ^3,4
Parameter
Input Power ⁵
Operating Temperature
Storage Temperature
Absolute Maximum
1W CW
-40°C to +85°C
-65°C to +150°C
3. Exceeding any one or combination of these limits may cause
permanent damage to this device.
4. M/A-COM does not recommend sustained operation near
these survivability limits.
5. With internal load dissipation of 0.125W maximum.
Recommended PCB Configuration
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
GMIC Circuits are sensitive to electrostatic
discharge (ESD) and can be damaged by static
electricity. Proper ESD control techniques should
be used when handling these devices.
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] • Europe Tel: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: [phone]
• China Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.