DS52-0008 Datasheet, PDF (2/4 Pages) Tyco Electronics – Low Cost Two-Way GMIC SMT Power Divider 824 - 960 MHz

DS52-0008
Low Cost Two-Way GMIC SMT Power Divider
824 – 960 MHz
Rev. V2
Electrical Specifications: T_A = 25°C¹
Parameter
Insertion Loss Above 3.0 dB
Isolation
VSWR Input
RF1, RF2 Outputs
Amplitude Balance
Phase Balance
Units
dB
dB
—
—
dB
Deg.
Min
—
13
—
—
—
—
1. All specifications apply with a 50-ohm source and load impedance.
Typ
0.6
15
1.3:1
1.3:1
0.1
3
Max
0.8
—
1.4:1
1.5:1
0.25
5
Absolute Maximum Ratings ^2,3
Parameter
Input Power⁴
Operating Temperature
Absolute Maximum
1W CW
-40°C to +85°C
2. Exceeding any one or combination of these limits may cause
permanent damage to this device.
3. M/A-COM does not recommend sustained operation near
these survivability limits.
4. With internal load dissipation of 0.125 W maximum.
Recommended PCB Configuration
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
GMIC Circuits are sensitive to electrostatic
discharge (ESD) and can be damaged by static
electricity. Proper ESD control techniques should
be used when handling these devices.
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] • Europe Tel: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: [phone]
• China Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.