DS52-0001 Datasheet, PDF (2/4 Pages) Tyco Electronics – Low Cost Two-Way SMT Power Divider 824-960 MHz

DS52-0001
Low Cost Two-Way SMT Power Divider
824-960 MHz
Electrical Specifications¹: T_A = +25°C
Parameter
Units
Insertion Loss
Above 3.0dB
dB
Isolation
dB
VSWR
Input
—
Output
—
Amplitude Balance
dB
Phase Balance
Deg.
1. All specifications apply with a 50-Ohm source and load impedance.
Min
—
15
—
—
—
—
Rev. V4
Typ
0.5
23
1.35:1
1.25:1
0.05
0.5
Max
0.6
—
1.5:1
1.4:1
0.15
1.5
Absolute Maximum Ratings ^2,3
Parameter
Input Power⁴
Absolute Maximum
1 W CW
Operating Temperature
-40°C to +85°C
Storage Temperature
-65°C to +150°C
2. Exceeding any one or combination of these limits may
cause permanent damage to this device.
3. M/A-COM does not recommend sustained operation near
these survivability limits.
4. With Internal load dissipation of 0.125 W maximum.
Recommended PCB Configuration
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
GMIC Circuits are sensitive to electrostatic
discharge (ESD) and can be damaged by static
electricity. Proper ESD control techniques should
be used when handling these devices.
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] • Europe Tel: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: [phone]
• China Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.