MRF175GU_15 Datasheet, PDF (16/16 Pages) M/A-COM Technology Solutions, Inc. – The RF MOSFET Line

MRF175GU
MRF175GV
The RF MOSFET Line
200/150W, 500MHz, 28V
M/A-COM Products
Released - Rev. 07.07
COM Application Note AN211A, FETs in Theory and Prac-
tice, is suggested reading for those not familiar with the con-
struction and characteristics of FETs.
The major advantages of RF power FETs include high
gain, low noise, simple bias systems, relative immunity from
thermal runaway, and the ability to withstand severely mis-
matched loads without suffering damage. Power output can
be varied over a wide range with a low power dc control sig-
nal.
DC BIAS
The MRF175G is an enhancement mode FET and, there-
fore, does not conduct when drain voltage is applied. Drain
current flows when a positive voltage is applied to the gate.
RF power FETs require forward bias for optimum perform-
ance. The value of quiescent drain current (IDQ) is not critical
for many applications. The MRF175G was characterized
at IDQ = 100 mA, each side, which is the suggested mini-
mumvalue of IDQ. For special applications such as linear
amplification, IDQ may have to be selected to optimize the
critical parameters. The gate is a dc open circuit and draws
no current. Therefore, the gate bias circuit may be just a
simple resistive divider network. Some applications may
require a more elaborate bias sytem.
GAIN CONTROL
Power output of the MRF175G may be controlled from its
rated value down to zero (negative gain) by varying the dc
gate voltage. This feature facilitates the design of manual
gain control, AGC/ALC and modulation systems.
16
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] / Fax: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
Solutions has under development. Performance is based on engineering tests. Specifications are
• Europe Tel: [phone] / Fax: [phone]
• Asia/Pacific Tel: [phone] / Fax: [phone]
Visit www.macomtech.com for additional data sheets and product information.
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.