MD_MDC-179 Datasheet, PDF (1/3 Pages) M/A-COM Technology Solutions, Inc. – Termination Insensitive Mixer

MD- / MDC-179
Termination Insensitive Mixer,
1 - 4000 MHz
Features
n Intermodulation Ratio is Insensitive to Port Mismatches
n VSWR: <2.0:1 Typical Midband
n Isolation: 35 dB Typical Midband
n Impedance: 50 Ohms Nominal
n Maximum Input Power: 350 mW Max @ 25°C, Derated
to 85°C @ 3.2 mW/°C
n LO Power: +24 dBm Max.
n MIL-STD-883 Screening Available
Description
The unique design of the termination insensitive mixer
(TIM) enables it to apply high reverse voltage to diodes
during their “off” phase, in the LO cycle. This allows for
higher power level performance with minimum distortion.
In addition the TIM has internal loads that provide a good
match and also absorb mixer generated LO frequency
terms. Combined, these features give the mixer its
insensitivity to external mismatches, plus superior VSWR.
FP-2 (MD-179)
C-7 (MDC-179)
Rev. V3
Pin Configuration (MD-179)
Pin No.
1
2
3
4
Function
GND
GND
GND
IF
Pin No.
5
6
7
8
Function
LO
GND
GND
RF
1
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions is
• North America Tel: [phone] • Europe Tel: [phone]
considering for development. Performance is based on target specifications, simulated results, and/or prototype
measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has
• India Tel: [phone]
• China Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline
has been fixed. Engineering samples and/or test data may be available. Commitment to produce in volume is _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
not guaranteed.
changes to the product(s) or information contained herein without notice.