English
Language : 

M21262-12 Datasheet, PDF (1/73 Pages) M/A-COM Technology Solutions, Inc. – Integrated loop filter and terminations
M21262-12
CDR/Reclocker with 4:1 Input Multiplexer
Rev V3
Features
• CDR/Reclocker with 4:1 input mutliplexer
• Integrated loop filter and terminations
• Serial control or hardwired control, JTAG boundary scan
• Low power consumption of 405 mW (all channels active)
• Built-in pattern generator and receiver for module and system testing
(PRBS, 8b/10b, Fibre Channel, User Programmable patterns)
• User Selectable Input Equalization and Pre-Emphasis for backplane ISI
reduction
Applications
• HD/SD-SDI Routing Switchers, Distribution amplifiers, and transport
systems
• SONET systems and modules
• 10 GBASE-CX4 systems
• Gigabit Ethernet systems
• PCI-Express
• SAS/S-ATA/S-ATA2 systems
Standards Compliance
• SMPTE 292M
• SMPTE 259M
• SMPTE 344M
• SMPTE 424M
The M21262 is a CDR/reclocker with 4:1 input multiplexer for telecom, datacom, and HD/SD video applications. Each output
channel has an independent multi-rate CDR capable of operating at data rates between 42 Mbps and 3.2 Gbps.
The M21262 can be controlled either through hardwired pins or through a serial programming interface. The hardwired mode
eliminates the need for an external microcontroller to configure the device. The serial programming interface allows complete
control of the device and is available as a two-wire or a four-wire interface.
The M21262 device supports JTAG external boundary scan, which includes all of the high-speed I/O as well as the traditional
digital I/O.
Functional Block Diagram
Din0 [P/N]
Din1 [P/N]
Din2 [P/N]
Din3 [P/N]
Multifunction Pin Array
Serial Interface/Hardwired Mode
BIST
Transmitter
JTAG
Voltage
Regulator
Dout [P/N]
BIST
Receiver
i
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
http://www.macom.com/support