M02006 Datasheet, PDF (1/16 Pages) M/A-COM Technology Solutions, Inc. – CMOS Pre-amplifier with AGC for Long-reach 155 Mbps Fiber-optics Based Transmitter

M02006
CMOS Pre-amplifier with AGC for Long-reach
155 Mbps Fiber-optics Based Transmitter
Features
Applications
• Low-cost IC, fabricated in sub-micron CMOS
• SDH / SONET / ATM
• Receiver sensitivity typically -40 dBm at 155 Mbps, when integrated into a • Fast Ethernet
module with suitable photodiode and post-amplifier
• 115 MHz bandwidth allows wide range of operation; suitable for 100, 125
and 155 Mbps
• Typical differential gain of 200 kΩ at low signal levels
• AGC gives continuous operation to >0 dBm
• 165 mW power consumption at +5 V supply
• > 35 dB Power-supply noise rejection
• Available as die
Rev V4
The M02006 is a low-noise, transimpedance amplifier with AGC, manufactured in sub-micron CMOS. Its wide
dynamic range, differential output and high PIN bias make it well suited for telecommunications, especially OC-3/
STM-1. However, the M02006 is intended to meet the needs of both Telecom and Datacom users.
The M02006 is available only in die form. For optimum system performance, die should be mounted in close
proximity with the photodetector.
The M02006 is designed to be used with the MC2045 postamplifier IC. When combined with a photodiode, the chip
set forms a high performance, low cost 5 V receiver.
PIN K
Functional Block Diagram
Series Pass
Regulator
Bandgap
1.234v
R
PIN A
TZA
Reference
Generator
AGC Control
+1
D_OUT
+1
D_OUT
+1
1
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
http://www.macom.com/support