English
Language : 

AM-153 Datasheet, PDF (1/2 Pages) Tyco Electronics – Low Noise Amplifier, 12 dB Gain, 300 - 1800 MHz
AM-153
Low Noise Amplifier, 12 dB Gain,
300 - 1800 MHz
Features
• 1.9 dB Typical Midband Noise Figure
• +7.5 dBm Typical Midband Output Power
• +19 dBm Typical Midband Third Order Intercept
TO-8-1
Rev. V3
Description
M/A-COM’s AM-153 is a coupler feedback amplifier
with low noise figure. The use of coupler feedback
minimizes noise figure and current in a high intercept
amplifier. This amplifier is packaged in a TO-8
package. This unique design features low noise
figure over a wide bandwidth. AM-153 is ideally
suited for use where a low noise, wideband, high
reliability amplifier is required.
Absolute Maximum Ratings 1
Parameter
Absolute Maximum
Max. Input Power
+10 dBm
Vbias
+15.75 V
Operating Temperature
-55°C to +85°C
Storage Temperature
-65°C to +125°C
1. Operation of this device above any one of these parameters
may cause permanent damage.
Electrical Specifications: 2 TA = -55°C to +85°C Case Temperature
Parameter
Test Conditions
Frequency
Units
Min.
Gain
@+25oC
600 MHz
dB
11.9
Frequency Response
—
300 - 1800 MHz
dB
—
Typ.
12.4
—
Max.
12.9
±1.2
Gain Variation with
Temperature
1 dB Compression
—
Output Power
300 - 1800 MHz
dB
—
300 - 1800 MHz
dBm
+6
—
+0.5, -0.7
—
—
Noise Figure
—
300 - 1800 MHz
dB
—
—
3.0
1500 - 1800 MHz
dB
—
—
3.5
Reverse Transmission
—
300 - 1800 MHz
dB
—
-14
-12
VSWR Input
—
300 - 1800 MHz
Ratio
—
—
2.5:1
1500 - 1800 MHz
Ratio
—
—
3.3:1
VSWR Output
—
300 - 400 MHz
Ratio
—
—
3.5:1
400 - 1500 MHz
Ratio
—
—
3.0:1
1500 - 1800 MHz
Ratio
—
—
2.5:1
Output IP2
Two-Tone inputs up to –5 dBm 300 - 1800 MHz
dBm
+22
—
—
Output IP3
Two-Tone inputs up to –5 dBm 300 - 1000 MHz
dBm
+17
—
—
1000 - 1800 MHz
dBm
+15
—
—
Vbias
—
—
VDC
+14.5
+15.0
+15.5
Ibias
Vbias = +15.0 VDC
—
mA
—
13
15
Power Dissipation
@ +15 V Bias
—
mW
—
200
—
1 2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance.
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: +91.80.4155721
• China Tel: +86.21.2407.1588
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.