IEC-1020 Datasheet, PDF (1/2 Pages) Level One – Industrial Media Converter

IEC-1020
10/100 Industrial Media Converter, SC SM 20KM
-40 to 75C
Overview
LevelOne IEC-1020 is an industrial Fast Ethernet media converter with a
rugged aluminium case which providing superb heat dissipation. This
converter is designed to be mounted on an industrial standard DIN-rail,
plus the clearly visible status LEDs provide simple monitoring of port link
activity. It also features Link Fault Pass Through in order to alert remote
location when link status changes
Safety
Complies with NEMA (National Manufacturers Association) TS1 & TS2
Environmental certi ed for the Tra c Control Equipment that withstand
extreme temperatures, operating voltage and humidity uctuation,
vibration and shock commonly experienced in severe outdoor
environments.
Fault Detection
Relay contact sends alert signal when the power failed or a port link
disconnected, therefore the system operator can respond quickly. This
relay contact can be easily con gured with a simple DIP switch.
High Reliability
All components are built to withstand harsh environment applications
without compromise where humidity, temperature variation and even
shock vibration are concerns, including Electric & Utility, Critical
Infrastructure, Transportation and Surveillance Security. This device
operates under -40 to 75 Celsius (-40 to 167 Fahrenheit) temperature.
Features
- 100Base-FX Single-mode ber for the link up to 20 kilometers
- Complies with NEMA TS1 & TS2 Environmental requirements for
Tra c control equipment
- Complies with IEC61000-6-2 EMC Generic standard immunity for
Industrial environment
- ISA 12.12.01 (UL1604) Class I, Division 2 Classi ed for use in
hazardous locations with DC Terminal Block power
- DIP switch con guration for "Link-Fault-Pass-Through," link down
alarm, speed, duplex mode
- 128K bits bu er memory
- 10/100Mbps-Full/Half-duplex, Auto-Negotiation, Auto-MDI/MDIX
- Full wire-speed forwarding rate
- Alarms for power and port link failure by relay output
- -40°C to 75°C (-40°F to 167°F) operating temperature range, tested for
functional operation @ -40°C to 85°C (-40°F to 185°F)
- IP30 aluminum case
- Supports DIN-rail mounting installation
Diagrams
Unit: mm
50
DC TERMINAL BLOCK
110
Front
Side
Back
Top
Buttom