L218-4080048C00000 Datasheet, PDF (5/10 Pages) Lumileds Lighting Company – Linear LED module on an ultra-slim and rigid substrate enabling high efficacy designs

Absolute Maximum Ratings
Table 3. Absolute maximum ratings for LUXEON XR-3020.
PARAMETER
MAXIMUM PERFORMANCE
DC Forward Current ^[1,2]
480mA for L218-xxyy024C30000, 960mA for L218-xxyy048C00000
Peak Pulsed Forward Current ^[1,3]
600mA for L218-xxyy024C30000, 1200mA for L218-xxyy048C00000
LED Junction Temperature ^[1] (DC & Pulse)
125°C
ESD Sensitivity (ANSI/ESDA/JEDEC JS-001-2012)
IEC 61000-4-2 Level 4 (8/15 kV contact/air discharge)
Operating Temperature at T_c point ^[4]
LED Module Storage Temperature
-40 to 85°C
-40 to 105°C
Reverse Voltage (V_reverse)
LUXEON LEDs are not designed to be driven in reverse bias
Notes for Table 3:
1. Proper current derating must be observed to maintain the junction temperature below the maximum.
2. Residual periodic variations due to power conversion from alternating current (AC) to direct current (DC), also called “ripple,” with frequencies ≥100Hz and amplitude ≤15% of the maximum
allowable DC forward current are acceptable, assuming the average current throughout each cycle does not exceed the maximum allowable DC Forward Current at the corresponding
maximum junction temperature.
3. Pulsed operation with a peak drive current equal to the stated Peak Pulsed Forward Current is acceptable if the pulse on-time is ≤5ms per cycle and the duty cycle is ≤50%.
4. Measured at T_c point next to LED. Some manufacturers refer to T_c as T_s. See AB209 LUXEON 3020 Application Brief for details.
5. Per IEC 62031, Ethr=2215 Lux.
Characteristic Curves
Spectral Power Distribution Characteristics
Figure 1: Typical normalized power vs. wavelength for LUXEON 3020 at 120mA, T_j=25°C.
DS159 LUXEON XR-3020 Product Datasheet 20160316 ©2016 Lumileds Holding B.V. All rights reserved.
4