LT107MA5 Datasheet, PDF (4/6 Pages) Shenzhen Luguang Electronic Technology Co., Ltd – ceramic filter

http://www.luguang.cn Email: [e-mail]
6. PHYSICAL AND ENVIRONMENTAL CHARACTERISTICS
(Continued from the preceding page)
No
Item
6.8 Solderability
6.9
6.9.1
6.9.2
Terminal
Strength
Terminal
Pulling
Terminal
Bending
Condition of Test
Performance
Requirements
Lead terminals are immersed up to 2mm More than 95%
from filter’s body in soldering bath of 250 of the terminal
±5℃ for 2±0.5 sec.
surface of the filter
shall be covered
with fresh solder.
No visible damage
and it shall fulfill
Force of 5N is applied to each lead in axial the specifications
direction for 10±1 sec.
in Table 1.
When force of 5N is applied to each lead in
axial direction, the lead shall folded up 90°
from the axial direction and folded back to
the axial direction. The speed of folding
shall be each 3 seconds.
Table 1
Item
Center Frequency drift
Insertion Loss drift
Specification after test
±30kHz max
±2dB max.
3dB Band Width drift
20dB Band Width drift
±20kHz max.
±30kHz max.
Spurious Response
30 dB min
Note ： The limits in the above table are referenced to the initial
measurements.
7. .REVIEW OF SPECIFICATIONS
When something gets doubtful with this specifications, we shall
jointly work to get an agreement.
SHENZHEN LUGUANG ELECTRONIC TECHNOLOGY CO.,LTD.
4